Electronics Forum | Thu Feb 08 09:07:22 EST 2001 | Hussman
OK, without knowing the specifics, why does everyone blame the oven? Most solder balls occur around R's and C's in almost every shop I've been to. The best place to start looking is the screen printer - not the oven. Sure the oven is the last proc
Electronics Forum | Wed Sep 08 21:36:14 EDT 1999 | kyung sam park
| I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Wed Sep 08 22:48:27 EDT 1999 | armin
| | I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Wed Sep 08 22:49:38 EDT 1999 | Jason Tomlinson
| | I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Sat May 29 22:20:56 EDT 1999 | Earl Moon
| | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to a
Electronics Forum | Fri May 07 02:37:31 EDT 1999 | Bob Willis
| Mornin! | | We just had vendor in here pitching a "low-temperature rework system" which was intriguing, but too expensive. He did get me to thinking though, beyond heating ceramic caps before hand-soldering them, it seems like it would be ad
Electronics Forum | Fri Mar 12 01:18:00 EST 1999 | Dean
| Okay, I would like to hear everyones ideas for PD naming conventions for FUJI. We are trying to use your basic names "3216_CAP" to a "MQFP208AD" But it is way out of control. Different part sizes, and vendors make it very tough to keep it all th
Electronics Forum | Tue May 26 14:42:55 EDT 1998 | Justin Medernach
| We currently bake plastic SMT parts in accordance with the IPC guidelines for moisture sensitive parts. Because we have double-sided boards that are subjected to either an aqueous or semi-aqueous cleaning process, we do a 24 hour bake at 125 deg.
Electronics Forum | Fri Mar 29 09:08:03 EST 2002 | caldon
Barcode!! The Siemens machines can have bar code Options added.On the Siemens Machines the bar code S/W is a little archaic. In theory You would have a bar code on a reel of part and a barcode on the feeder location (They are the black codes on the s
Electronics Forum | Mon Jul 15 15:44:11 EDT 2002 | davef
For us, no. Pain in the butt, yes. Volume build shops do not have the inherent flexibility that quick turn shops have built into their systems to deal with these problems. I�d speculate that this issue will help LARGE contract shops to rethink the
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477