Electronics Forum | Wed Mar 08 17:26:23 EST 2000 | Ron
Depending on the volume of work, it may be less costly and more efficient to have the board vendor add "breakaway" panels to the board to increase it's overall size. This would move the parts away from the edge of the rail, yet would negate the expen
Electronics Forum | Mon Feb 28 21:06:39 EST 2000 | Pat Copeland
Can anyone direct me to a proper footprint for an s-mini 2 pin diode. I can not find one in the manufactureres data sheet and this part is not in the IPC book. Anyone know where I can find it.
Electronics Forum | Mon Feb 28 14:01:03 EST 2000 | greg
I have the following problem with a GSM. When powered up I get the error "Error Initializing Hard Disk Controller 0" do you think this is the controller if so what is the part number for a controller.. any input would be great thank you
Electronics Forum | Wed Feb 23 02:20:09 EST 2000 | Roni H.
Hi, I need a wear resistance PCB finishing over bare copper (If exist!), the surface have a moving part which slides over it and bare copper as a surface is not good enough. I'll apprechiate any information. Thanks Roni
Electronics Forum | Thu Feb 17 02:49:04 EST 2000 | Roni Haviv
Hi, I need a wear resistance PCB finishing over bare copper (If exist!), the surface have a moving part which slides over it and bare copper as a surface is not good enough. I'll apprechiate any information. Thanks Roni
Electronics Forum | Mon Feb 14 12:26:53 EST 2000 | JAX
Ed, Although I cannot remember what issue it was in, you should be able to contact us-tech and find out. Here's a link to get you there. Have FUN!
Electronics Forum | Fri Feb 11 10:14:54 EST 2000 | C.K.
Dave, to answer your questions, point-by-point: � Just out of curiosity, how are second side, skippy components oriented on the board with respect to the wave? The SMD's are all oriented in the "correct" direction with respect to wave direction(i
Electronics Forum | Fri Jan 12 10:05:52 EST 2001 | Charlie
What has been your experance with fine pitch parts taped and reeled? Will I have lead problems?
Electronics Forum | Fri Jan 12 08:00:29 EST 2001 | Stefan Witte
The tape comes from Tesa-Steier out of Hamburg, Germany. Part# 3.0740.00 Call 011 49 41214730
Electronics Forum | Wed Jan 03 18:44:13 EST 2001 | Todd Koeppel
If we procure parts with a Sn/Ag termination, can we still use standard Sn/Pb solder pastes and the current reflow and wave processes?
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477