Electronics Forum | Tue Mar 22 03:36:29 EDT 2016 | annabella
Where are you buying SMT Parts? Alibaba? Made in China? Or SMT net? Or google?
Electronics Forum | Fri Sep 06 08:12:40 EDT 2019 | davef
Parts & Supplies * "Send RFQ" tab [pumpkin colored tab mid-upper part of page]
Electronics Forum | Tue Jan 28 15:37:22 EST 2020 | stephendo
The best I have seen was two people set up and verify and then two other people not involved with that setup verify. It worked quite well but even then a wrong part was put on. Day shift set up and Afternoon shift thought that both verifications had
Electronics Forum | Mon Apr 26 18:45:32 EDT 2021 | rgduval
I've had the most success in a check/double-check set up. Most people will tell you that it's labor intensive, and they're not wrong. However, I suspect that those people have never had to manually change two components on a thousand boards at a sh
Electronics Forum | Fri Apr 07 11:47:58 EDT 2023 | abhishek10
part can be reversed internally in spool or may be possibilty of part drop
Electronics Forum | Thu May 04 04:24:09 EDT 2023 | abhishek10
problem occured only in one part rest all parts are ok
Electronics Forum | Fri Oct 27 15:03:29 EDT 2023 | proceng1
As Tom said, we assign internal P/Ns and list all the "approved sources". If the customer BOM includes their own internal part number, we simply add the Customer Prefix, and use their number. If they don't, we utilize 'CUS-R0001' format. This can be
Electronics Forum | Wed Jan 31 14:08:05 EST 2001 | chugarth
I am having a lot of problems trying to Identify feeders needed to place parts from a Quad Mach. How do I find out what parts such as SOD 123 what feeders do they use.etc 8mm,12mm, etc. Do any parts suppliers furnish good information
Electronics Forum | Wed Apr 18 01:07:25 EDT 2001 | MW
I some something like this. My package was not flat the belly of the body rested on the PCB. We found that every 4-5 part would wander to the side. What was puzzling is that the blowers would have blown it the opposite side. ultumately we proved
Electronics Forum | Wed Sep 08 20:38:06 EDT 1999 | Barbara
I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
