Electronics Forum | Wed May 31 10:39:33 EDT 2006 | grantp
Hi, We actually tried to get major parts of our line from the same supplier, however each supplier is good at some parts of the line, and not others. We went with Soltec oven and wave, which work well, and have not had any issues, plus DEK printer
Electronics Forum | Fri Jul 13 17:16:49 EDT 2007 | jmelson
I just got a used Philips CSM84 pick and place machine for $1500. I had to widen a doorway and rent a forklift to get it inside, as well as have it shipped. So, the total cost was much higher, but still under $10 K. I may have gotten lucky on this
Electronics Forum | Tue Aug 22 21:00:39 EDT 2006 | davef
National says: [ http://www.national.com/packaging/llp/faq.html#faq_manu ] Manufacturing FAQ's Are there any precautions that need to be taken with the LLP package? It is critical to follow National�s guidelines for successful surface moun
Electronics Forum | Fri Jan 05 12:17:31 EST 2007 | Cmiller
Our first pass yield across all our products is above 95% but we include anything that does not meet IPC standards. Probably 75% of our failures are not electrical. AOI is a great tool to get a consistent measure of your process. I dont know how anyo
Electronics Forum | Fri Jan 12 09:04:18 EST 2007 | Cal
For insurance purposes we verification... Here is a snippet from Glenbrooks website. From http://www.glenbrooktech.com Design Safety Standards The design safety standards pertaining to Industrial X-ray Inspection Systems can be found in "Code of
Electronics Forum | Fri Feb 09 11:48:09 EST 2007 | realchunks
0.25mm tilt? That's pretty small depending on you BGA size. Is it failing? Or just your Q.E. being anal? What size BGA we talking about? What ball count? Just one board? Maybe cheaper to just repair. Now assuming there is NO part under the BGA
Electronics Forum | Thu Jun 28 20:11:32 EDT 2007 | rfrog
Hi folks, I've been bouncing off of MyData technical support for some time on an issue with a MyData machine. Seems that this My9 likes to skip an 0402 placement at a rate of ~ 1000/million. Profile: MyData My9 Mechanical centering Midas only
Electronics Forum | Mon Aug 27 16:51:14 EDT 2007 | gmoritz
I'm updating this thread and replying to the first post in the thread due to the annoying tendency for later posts to get indented to the point that you can only put one or two words per line. Our Rad 5, hit the skids again for the last couple of w
Electronics Forum | Wed Nov 07 15:50:52 EST 2007 | Frank
For a modest invest of capitol equipment and maybe some hair pulling to learn the process it shouldn't be terribly difficult to get your own production line up and running. You just missed a few trade shows that you could have went to and seen all t
Electronics Forum | Fri Dec 21 15:32:57 EST 2007 | rwyman
Hey SWAG- Not an uncommon scenario where I'm at. But the bottom line is, as others have said: Profile, profile, profile. Here, we have dedicated profile boards for each product we build and in most cases they're EXACT representations (my library i
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477