Electronics Forum | Thu Jun 21 22:04:18 EDT 2001 | davef
This is my attempt at beating the "Fuzzburg 7" translator used on the SMTnet Forum that mashes everything it sees. Below the next paragraph are three paragraphs,each with a common numering sequence, where each paragraph represents the columns of a t
Electronics Forum | Sat Aug 07 11:47:47 EDT 1999 | JohnW
| | | | | | | | | | | | Hello, | | | If you are using no-clean and they are entrapped in the flux it is also IPC accepted but i havent found a customer yet who agrees with that. Im sure you have checked your profile. I had the same problem with chi
Electronics Forum | Mon Jun 28 11:51:36 EDT 1999 | Brian Wycoff
| | | | Dear guys, | | | | | | | | I have some problem on assembling micro-BGA with solder paste (63/37). The micro-BGA we assmeble is 0.75mm pitch and with 45 pin (solder bump is 96.5/3.5Ag). The stencil is a laser-cut stencil with 5 mil thicknes
Electronics Forum | Thu Aug 27 15:40:50 EDT 1998 | Justin Medernach
| | | | | Hi, | | | | | Does anyone has experiences in reflowing Ceramic BGA and found solder wicking ? Solder wicking has the syndrome that solder being wick from the pad and ended up in the leads. | | | | | We have rule out the possibility of not p
Electronics Forum | Fri Jan 05 12:01:26 EST 2001 | Jim M
I've been involved with no-clean flux and conformal coat in the past.It has been my experience that the amount of no-clean flux used is proportionate to how well the conformal coat adheres to the boards.No clean paste did not affect adhesion. The co
Electronics Forum | Tue Oct 31 14:52:25 EST 2000 | Dr. Kantesh Doss
Hi Antonio: You clearly have printed excessive amount of solder paste on the pad. You can reduce the amount of paste by one or two methods: 1. Switchover to 5 mil thick stencils. 2. Change the design of your stencil openings (at the discrete compone
Electronics Forum | Tue Oct 03 20:35:23 EDT 2000 | Dave F
1. Throughput * Dispenser: Slower, may loose 70% of tact on fast chip shooters * Printer: Can be put in front of and use fast chip shooters effectively 2. Rework Rate ???? Deposition control???? * Dispenser - High control over amount paste - Coplan
Electronics Forum | Sat Sep 23 15:13:40 EDT 2000 | Francois Racine
Hi Sophia, I`m responsible of SMT line and we solved this problem with a complete automatic solder paste printer machine. In the past we had problem with off alignment and solder height too.... at that time we used a semi-auto printer machine and w
Electronics Forum | Wed Mar 14 18:17:40 EST 2001 | mparker
Some thing to watch out for is the cure spec for the adhesive. Will that match with your solder paste reflow spec? You will have two dissimiliar materials going through endothermic reactions at the same time. You could end up with under cured adhesiv
Electronics Forum | Wed Mar 14 17:52:49 EST 2001 | davef
6 Work Life Test 6.1 Obtain a stencil with 15 to 20 rows of a series of 0.025 by 0.050 inch apertures spaced 0.050, 0.040, 0.025, 0.015, 0.010, 0.010, 0.025, 0.040, 0.050 inches apart. See Appendix 1. Source of supply: Metal Etching Technology.
