Electronics Forum | Thu Jul 20 13:49:20 EDT 2000 | Jeanette
When dispensing paste would you reccomend dispensing the paste first then inserting the component or inserting the component, clinching the leads and then dispensing the paste. I have heard that the latter may cause dry joints. Would you use the sa
Electronics Forum | Mon Jan 10 03:11:11 EST 2000 | Wister
Hi,how to control the solder paste,condition as belows? place at room temp.or put it into refrig.again if the unopened paste has been warmed up 8 hours but it would not been used at once in case of schedule changing.Assuming that this solder paste wi
Electronics Forum | Wed Jan 05 11:53:28 EST 2000 | Dave F
Josue: Many variables, which you control affect paste height, but paste height is not (or correctly shouldn't be) the issue. Paste volume is where you should focus your attention. Check the archives Good luck. Dave F
Electronics Forum | Tue Apr 06 16:14:16 EDT 1999 | Dave F
| I need help in finding solder paste measuring equipment. | Cuch: What aspect about paste are you trying to measure? 1 Paste qualification? 2 Incoming quality? 3 Print volume? Dave F
Electronics Forum | Sun Aug 25 07:15:55 EDT 2002 | cnoonan
What are the industry standards for eutectic solder-paste in conjunction with the life span of solder-paste. What is the recommended duration of solder-paste on a printed circuit board. Example: You print a board, how long can it sit before runnin
Electronics Forum | Wed Jun 11 08:24:37 EDT 2003 | davef
Please help us understand better what you seek. Is it: * Cleanable low residue solder paste * No-clean solder paste * Someother paste
Electronics Forum | Mon May 03 15:39:05 EDT 2004 | Joe A.
Can anybody tell me which is better; to paste to BGA or to paste to PCB? What are the pitfalls when pasting to BGA?
Electronics Forum | Fri May 07 17:04:02 EDT 2004 | davef
Either method is acceptable: * No IPC approved method * Applying flux only is easier than applying paste * Paste gives a higher stand-off, which should improve reliability
Electronics Forum | Wed Feb 09 04:41:16 EST 2005 | dhanashekar
we are storge the soldering past as per the manufacture sefaction of arround 5deg before the using the paste we remove the paste from the storge and keep the paste in the room temp and then used. THANKS for the your soulation if ane other sulation pl
Electronics Forum | Thu Apr 21 08:45:53 EDT 2005 | davef
Top 10 products relating to solder paste are: * Printer * Stencil * Stencil storage rack * Squeegee * Squeegee holder * Under stencil wipe * Under stencil cleaning fluid * Stencil cleaner * Dispenser * Paste stirrer * Used paste / empty paste contain