Electronics Forum | Tue Oct 01 07:10:02 EDT 2013 | bobpan
It could be PC Memory or maybe a full hard drive. I would check the following first. 1. Reset board count (there is a bug that causes problems if the count gets too high.) 2. Make sure ROA=OFF if the line is in your configuration file editor. 3. Ma
Electronics Forum | Wed Nov 02 16:36:05 EDT 2016 | ttheis
Problem was bad FCU board; replaced with FCU from another machine and swapped rom chips. Oven operates properly and communicates with PC. BTU was kind enough to supply the default usernames and passwords for wincon but they did not work. Still waiti
Electronics Forum | Fri Dec 30 20:12:47 EST 2022 | ttheis
I found a broken COM3 connector on the fluxer interface board where the PC comms go through and replaced the connector. Now when trying to establish communications the exhaust fan turns off briefly a few times then it times out and reports a failure
Electronics Forum | Mon Apr 23 19:12:23 EDT 2001 | relensky
Thanks for the instructions. I was missing the reflow part... Omikron is the method our board house offers. We have been through the plating thickness problem and tin depletion conditions. Beyond those issues, I have been trying a few different n
Electronics Forum | Wed Jul 20 02:48:43 EDT 2005 | grantp
Hi, What's really interesting about your photos is there is solder paste on top of the component. If it was blowing the solder off the board you would see solder paste splatter away from the component. But the solder paste is on top of the compon
Electronics Forum | Mon Jun 25 16:04:50 EDT 2007 | jmelson
Hi Jon, > > Thanks for the dimensions. It is quite > larger than CSM66, so I haven't got chance to buy > 84. You are very "lucky" because you "only" had > to cut a bigger hole for it. My workshop is > "under" the ground, in the cellar,so I had t
Electronics Forum | Wed Oct 15 21:53:59 EDT 2008 | mariss
50%) is high. With high humidity, there is also minor amount of spatter (10 to 20 'balls' per board). It is this that I would like to eliminate. I'm just a small guy running a young company here in Tustin, CA. Our product is very profitable and we
Electronics Forum | Wed Sep 02 20:18:18 EDT 2015 | sarason
Are your PCB's stretched or is it that the films that were used to make your PCB's distorted.Thus vias and TH's don't align. These things will probably be picked up in bare board testing , but depending on the amount of offset may get through, to yo
Electronics Forum | Wed Jan 13 12:17:47 EST 2016 | trampacorp
Thanks for your input Michael. Basically the > boards had been go through from washing and even > ionic contamination already. In order to > eliminate or detect the flux residues, is there > any equipment something like a uv lamp that can > dete
Electronics Forum | Wed Oct 24 09:47:32 EDT 2018 | filipblad
Picture of error in the link: https://photos.app.goo.gl/ptHcVwmbUi2Yi54z6 We did have a problem with the force sensor earlier, one of the cables was broken so I soldered it back together and now it works (I get a value of 180 when tool is inserted a
