Electronics Forum | Thu Jul 26 12:04:16 EDT 2018 | wendymm
RS-274X file contains the complete description of a PCB layer image without requiring any external files. It has all the imaging operators needed for a PCB image. Any aperture shape can be defined as well as positive and negative objects. Maybe that
Electronics Forum | Tue Jul 31 04:53:28 EDT 2018 | teresat2
The UL Safety Laboratory is the most authoritative in the United States and a large private institution engaged in safety testing and identification. The UL+ number on the PCB mainly represents the UL certification of the circuit board in the United
Electronics Forum | Fri Aug 24 11:58:18 EDT 2018 | cupet
Hello davef, thank you for your reply. What do you think about the footprint for the diode on the first picture where the component is not assembled? There is good wetting on one pad of footprint and the other pad has bad wetting. This problem is not
Electronics Forum | Mon Oct 15 14:29:58 EDT 2018 | compit
I have an Emerald X machine (by Assembleon) with an LCS. I start production. The first PCB board runs to the end of the LCS (item 1). Each subsequent stop is BEFORE LCS (item 2) - I have to remove it manually. And so until the production reset - then
Electronics Forum | Fri Nov 16 03:38:03 EST 2018 | premkumar_haribabu
Hi all, We have to solder a nickel tabs ( coming in SMT reels ) in to HASL PCB finish pads using refow oven & during this we facing poor wetting issues, more voids & we done pull strenth , its came out with in 1 kg ,I doubt that nickel coated materi
Electronics Forum | Wed Mar 27 13:47:24 EDT 2019 | whitelancer64
I am having an issue with aligning vision for solder paste inspection with the PCB in the Momentum machine. The SMT operators setup the profile on the machine, which I then import into Aegis CircuitCAM to add PCB locations. But when I export again, t
Electronics Forum | Wed Jun 26 04:00:30 EDT 2019 | SMTA-David
Thanks, I'll take a look. Something else I found was the Z height for the module was set to 1.7mm but I am picking up the part on the PCB surface which is only 1.0mm from PCB being loaded, therefore the part must have been let got 0.7mm above PCB an
Electronics Forum | Fri Sep 27 01:28:58 EDT 2019 | drew_holm
HI, we are trying to reduce the noise from an off the shelf pcb that will be used in the mri industry. We have been able to reduce quite a bit of noise using copper mesh but we still have more to go. So we think we now have to consider the board c
Electronics Forum | Sun Apr 26 22:47:42 EDT 2020 | autolab
Hello, We would like to manufacture the OBD II port automobile scanner from your firm. What we need from you? To manufacture the PCB, stuffed the components inside and manufacture the housing. Manufacture few samples, then thousands. What we h
Electronics Forum | Sat Jan 09 20:00:04 EST 2021 | oxygensmd
I had similar issue on S20 two times. The portal2/gantry2 have camera image? Have working camera system - if other camera ok, PCB camera will be the problem. Have camera screen on BE/Components camera? Have iCOS PC working. - Check the camera conn
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, USA
Phone: 5102268155