Electronics Forum | Thu Feb 11 07:24:40 EST 2016 | truewanderer
I'm planning to design the pcb of my project. The controller used is having 136 pins and the package is P-LFBGA. So i think i need to design a 6 layer board for better performance. I haven't designed a multi layer board before. So what are things tak
Electronics Forum | Sat Nov 05 20:23:11 EDT 2016 | sarason
Close but not to close, would have to be the spec. Or depends on your separating technology. Prerouted boards on a panel, you could go right up to the edge. V-grove you will need more distance, maybe 2mm's or more. The distance from the panel edge to
Electronics Forum | Wed May 14 11:35:04 EDT 2008 | scottefiske
We produce High mix very low volume Military assemblies. So a typical order mya be for 50 pcb's, at a 5 up array. Do you work in the fab shop? Scott
Electronics Forum | Wed Feb 09 21:19:03 EST 2005 | Mrduckmann2000
Russ, We can not use a wave pallet, already went that route. We have parts next to the thru-hole pins and between thru-hole pins. I am going to try an experiment in the next day or so with solder mask. I plan to solder SMT parts on the back of se
Electronics Forum | Fri Jul 07 03:27:31 EDT 2006 | dougs
Hi folks, thanks for all the tips. We have run our first batch of these flexi boards now. I had the PCB suppliers make me some 1.6mm FR4 carriers to lay the boards on to carry them through the process. (1 flat & 1 with cutouts for the second side)
Electronics Forum | Thu Jul 06 13:36:37 EDT 2006 | SWAG
We've had much trouble with flex circuits. As previously mentioned, you must have local fids for the board or the BGA itself (if panelized). Other troubles we experience are drilled holes for pinned connectors. Unless the PCB manufactur has some w
Electronics Forum | Mon Jun 26 12:23:11 EDT 2006 | Rob
Yep, Book a holiday and let someone else sort it out. Otherwise e-mail me and I'll talk you through pallets, rigidisers, printer tooling, spray mount, Kapton tape, local fiducials (panels can strech & shrink) etc. Oh, yeah - for the connectors you
Electronics Forum | Wed May 14 15:15:03 EDT 2008 | boardhouse
Hi Scott, I have worked for a State side PCB Manufacture and now a Taiwan Manufacture. At both shops the up charge was based on how many up the pallet array was plus layer count and complexity of product, charges ranged from free to 15%. Standa
Electronics Forum | Fri Oct 29 23:08:06 EDT 2010 | laen
What software are people using to compute route and retain tabs on panels? I produce some complicated (150 board, 80+ different design) panels, and I haven't found a good way to programmatically compute where to place the tabs. Thanks.
Electronics Forum | Fri Aug 01 21:10:35 EDT 2008 | leo_dektec
You can keep only the 5th zone as the reflow zone. And lower the first two zones to keep a good ramping rate. Meanwhile,please note the ting temperature in software or control panel is not the exact temperature in your PCB, you'd better get a KIC or
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
