Electronics Forum: peelable and solder and mask and residue (Page 1 of 1)

kapton dots and liquid solder mask

Electronics Forum | Tue Aug 09 11:56:01 EDT 2005 | Rob

We sometimes use a peelable mask the the PCB manufacturer (board house) adds as part of their process. It may seem an expensive option but avoids: Raising P/o's for tape/peelable mask as consumables booking & inspection Booking out to the shop floo

kapton dots and liquid solder mask

Electronics Forum | Wed Aug 10 11:57:16 EDT 2005 | pr

Is the peelable mask (put on by the boardhouse) flat on the surface of the pcb? If so can you tell me the material name, so maybe I can find a picture? We have to print adhesive on the board, so the mask has to be flat. That is why Kapton from the b

Wave flux and profiling

Electronics Forum | Mon Dec 18 14:36:09 EST 2006 | samir

Yikes!! In-line cleaning, to clean cosmetic and benign residues (from a NO-CLEAN) flux... You sure you can't switch fluxes? Another variable with residues is the solder mask. Depending on mask type (glossy, matte, semi-gloss, or semi-matte), will

Wave flux and profiling

Electronics Forum | Mon Dec 18 23:24:50 EST 2006 | grantp

Hi, Yes, I would hate to resort to cleaning, but the product must be clean. We have been using palettes to keep most of the flux off the PCB, but there is still residue around the connectors. Does anyone suggest a good no clean flux to use with le

Heat guns and component damage

Electronics Forum | Wed Feb 01 08:12:04 EST 2006 | Chunks

OK, this is easy. You say HIGH fall out, so I can assume 25 or 50%? If so, run 10 without the heat gun and 10 with. This should show you if the heat gun process is the cause or not. If the relay is a surface mount, hand solder them on. If it's a

Re: Ionic testing and No-Clean flux

Electronics Forum | Sat Feb 05 09:08:18 EST 2000 | Dave F

Casimir: Let me expand on something that I said in my response to your thread on ionic testing. Generally, no-clean people don�t use ROSE testing as part of their process control, because the ROSE test is essentially washing your board in DI/IPA �

Foam fluxer maintenance, storage and cleaning

Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef

Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept

  1  

peelable and solder and mask and residue searches for Companies, Equipment, Machines, Suppliers & Information