Electronics Forum | Tue Nov 26 15:32:41 EST 2013 | boriskilk
As with most questions the answer is; it depends. Provided not too many boards are set onto a panel we use a .10" router gap around the PCB and .10" wide perforated tabs. We do request customers specify where they do not want tabs to ensure no breako
Electronics Forum | Sun Mar 18 20:02:48 EDT 2018 | reckless
Thanks for your help every time! You are right table top units are a joke. For smaller conveyor ovens I found two major brands: Manix (no longer makes ovens) and Manncorp. The manncorp unit I am looking at does not have a bottom heat zone. Mos
Electronics Forum | Mon Jun 19 21:37:14 EDT 2000 | Dave F
Mike: Look a the Hadco DFM manual ( http://www.hadco.com/ ) Yano if you�re lookin� for uniformly smooth (not silky smooth) board edges, have you considered scoring to separate your boards? Scoring has: * Minuses (straight lines only, stress on so
| 1 |
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)