Electronics Forum | Sun Nov 24 12:44:10 EST 2019 | bane016
I have problem with feeder cart.I have no voltage on any of the 17 feeder connectors, and when i insert the cart in the machine i get the message that the cart is not connected. I have a voltage to one separate connector normally.
Electronics Forum | Mon Dec 02 02:29:16 EST 2019 | bane016
Problem solved. Burned electronic on cart.
Electronics Forum | Mon Nov 25 20:52:47 EST 2019 | cbeneat
Are the arms pulling the cart all the way in? Possible part blocking the limit switch. does the cord have power? If I remember correctly, we once had to adjust the mechanical stops on one of ours so it would make the switch.
Electronics Forum | Thu Nov 15 10:13:26 EST 2007 | slthomas
Not much, actually, but that was by choice. We use the Quads for short runs and when we want to get set up and torn down quickly. The Topaz was purchased specifically to give us the ability to get through our larger, regular jobs faster than we can
Electronics Forum | Fri Mar 07 04:53:12 EST 2008 | vinitverma
Hi Wayne, First, all Gem machines including Topaz, TopazX, Sapphire, etc... have the same feeders. You can use either FV feeders (which were the ones when Topaz was introduced), or CL feeders (which came when Topaz X was introduced). Both types of f
Electronics Forum | Mon Nov 12 12:00:59 EST 2007 | wayne123
A philips Topaz is a good machine, I have accurately placed 0402's without a problem, Fine pitch QFP no problem, BGA's not a problem, I am not familiar with the TP9 so hopefully the other guy can answere questions on that, The Topaz is rated at about
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Mon Nov 20 04:37:34 EST 2000 | Paul Gerits
Dear Mr. Kelley, You can contact the local Philips EMT organization or the head office in the Netherlands. We have pre-owned feeders in stock, if the ones you require are available you can request. contacts: rein.sprokholt@philips.com (region euro
Electronics Forum | Sat Oct 20 00:34:57 EDT 2001 | kenbliss
Hi mike The solution is simple but two fold, first your process needs to be changed a bit, you need additional feeders to pre-stage the new P/N run and prestage the extra feeders for reload as certain higher volume components exhaust. The idea is t
