Electronics Forum | Tue Dec 05 09:46:50 EST 2006 | GS
I'd be shocked if Siemens was going away. They are a very big group in a very big company. Yes, but recently we have seen several big groups from a very big companies been sold out (ie. Dover and some of his kids, etc.) Asia-India are good referen
Electronics Forum | Wed Dec 20 16:30:40 EST 2006 | CK the Flip
I've seen smaller components have a "charred" appearance and a lack of wetting up the component termination. Also, extended heat exposure may introduce excessive IMC (intermetallic) formation - the bad kind, that is. That's where your IMC layer wil
Electronics Forum | Fri Jan 12 08:41:12 EST 2007 | geb
Hi, Our GSM1 pick and place machine has an Axis head 2 Z velocity error. None of the spindles of Head 2 work during placement and it brings up the error message. It will not proceed after that. I have tried lowering and raising the spindles in the
Electronics Forum | Fri Feb 02 14:56:57 EST 2007 | Wagoner
Mimot is another machine that is well suited for prototype runs. It's slower than a chip shooter and it is really a flex placer. You can keep a lot of fixed feeders and it is pretty easy to set up. Operator interface is excellent and programming i
Electronics Forum | Tue Feb 20 18:04:53 EST 2007 | coop
I am not familiar with the YV100XG pick & place but you might want to increase the mount height of these components The double stick tape isn't as thick solder paste. it might be pushing the component too far down causing it to twist. I encountered
Electronics Forum | Wed Mar 07 07:08:30 EST 2007 | Rob
They are very long with lots of feeder positions & have a fast tape loading mechanism. They are also easy to use and upgrade, and are cheap on the second hand market. However, on the flip side they are slower (the hydra figures are just dreaming as
Electronics Forum | Mon Mar 19 23:35:10 EDT 2007 | bvdb
Hi Pete, I was using only the small and medium nozzles but it happens on both nozzles. No error message unless the delay went past about 5 seconds then a Q servo error and machine stops. Pressing reset and run enables it to continue although it th
Electronics Forum | Mon Mar 19 20:58:45 EDT 2007 | Steve
I have a project I would like to consider a Juki machine for. I am trying to find out if a Juki 2000 series machine can pick up parts from 12mm and 16mm simultaneously with all heads for good optimisation performance? IE are the heads spacing the sam
Electronics Forum | Sun Mar 25 21:34:19 EDT 2007 | darby
Samsung CP-50 should suit your requirements. All feeders from the Samsung range are compatible except the new SM320/321 series. Don't know about the financial side. I have never used this model but the people I know who have are happy with them. Migh
Electronics Forum | Sat Mar 24 19:52:37 EDT 2007 | colormaker
Thanks for the quick reply, What machine did you get ? We just had the AMCON show in Orlando but I just moved into a 4K sq foot facility and was unable to attend. Up to know all I place is 1206 parts so I dont have the exsprience to know what to ask