Electronics Forum | Mon Dec 07 09:43:09 EST 2009 | kpm135
Just to throw my two cents in the MY19 could be slower than the other my machines due to the greater distance the head has to travel to pick up and place the components.The longer distance could also account for extra wear and tear on the motors and
Electronics Forum | Wed Dec 30 12:58:10 EST 2009 | vetteboy86
I'm setting up a matrix tray for the first time on our Quad QSP-2. I believe I have defined the tray and holder. Assigned part numbers. My issue is that instead of teach feeders, I think I need to teach table top. When I do this, I am not finding an
Electronics Forum | Thu Jan 28 11:56:53 EST 2010 | alexino76
Yes, u're right... U can do with Flexprogram; this is the dos based program that convert a zevatech file in a txt file or viceversa. You simple convert your PM file as txt and reconvert as FM740 format (g3g). After conversion u have to complete compo
Electronics Forum | Tue Feb 09 09:18:13 EST 2010 | davemacnemo
Machine installer gave me some tips and a run through the software. Everything worked just fine. First solo attempt to run product that we started with gives L305 SoftLimitOver... error after picking first components and passing over camera. Additio
Electronics Forum | Thu Feb 25 20:25:16 EST 2010 | dean
Good question, the answer as of right now is yes. Our machine is only able to go down to 0402 parts before the surface tension of the solder begins to cause issues with maintaining the placement position of the part on the nozzle. However, we are dev
Electronics Forum | Thu Feb 25 15:05:17 EST 2010 | flipit
Multiport nozzles will work better if your pickup is not perfect. Has been a while but are the nozzles 08MPF? I used to pick 0402 chips with 08MPF nozzles. These had 5 holes and were black Delrin plastic. I looked at the 0402 using front lighting
Electronics Forum | Wed Mar 03 19:30:37 EST 2010 | dcell_1t
Yes, it is basically: Rate = Time interval/Cycle time I put time interval since you can measure however you want (pc per hour, per day, per quarter hour... it is relative) the most used is Pc/Hour, so the time interval is 1 hour (3600 sec). Lets sa
Electronics Forum | Mon Mar 08 16:23:05 EST 2010 | mikesewell
I'd think about database structure and programming aspects as well. I'm cleaning up an implementation where the parts were taught as they appeared to the AOI programmer irrespective of the Pick & Place data/libraries. Lots of rotation fixes, parts
Electronics Forum | Mon Mar 22 07:40:01 EDT 2010 | emanuel
Are you absolutely sure the problem is with the humidity? We had a problem with 3528 size leds, damaged by the pick and place nozzle because a 0.2mm mistake in the height measurement. Also, we found that several suppliers are using fake desiccant ba
Electronics Forum | Wed Mar 31 10:55:42 EDT 2010 | fredc
I worked on a nozzle for one of these LEDs in the past. I seem to remember that there are raised surfaces outside the pick up area. Be sure your nozzle is not hitting them, if so you will lose vacuum. A rectangle shaped nozzle would maximize your abi
