Electronics Forum | Thu May 05 19:13:33 EDT 2016 | darby
Thanks Sr. If you have zero tolerance for simul pick up in your component files then you will not have simul pick up due to variances in your head offsets. So you are saying that on your Juki you run a tolerance for 0201? All other head positions at
Electronics Forum | Thu May 05 07:58:35 EDT 2016 | cyber_wolf
Not sure what you mean. 0201's and 0402's are both on 8mm feeders. Juki's will do simultaneous picks an all 8mm feeders no matter the component size. Your feeders need to be maintenanced and calibrated to reliably pick 0402's and 0201's. I hav
Electronics Forum | Thu May 05 01:50:44 EDT 2016 | darby
Dear Forumites, It's been a while, but I have a question. I was recently asked to provide a scenario on capacity if we retired two older lines and replaced with a new line. My capacity figures were based on real time production over a period of six
Electronics Forum | Fri May 06 08:27:38 EDT 2016 | kahrpr
We have Samsung and havehad no problems with simultaneous pick ups with 201s 0r 402s. the feeders are durable and do not need much repair especially the sm feeders. The SME feeders have not been out as long so we will see so far so good. As with all
Electronics Forum | Thu May 19 02:04:36 EDT 2016 | jpcwg
Located in Shenzhen China, the Silicon Valley of hardware, ALLPCB.com is a company specialized and experienced in manufacturing printed circuit boards of prototyping and low volume production. Through the years thousands of business customers and eve
Electronics Forum | Thu May 12 00:18:55 EDT 2016 | darby
Sorry for delay - been flat out. Sr - I understand what you are saying. My concern is that combined with the head offsets and variations in pick points (i.e. having to teach feeder positions for very slight amounts like 0.05mm)then you cycle times wi
Electronics Forum | Fri May 06 07:58:33 EDT 2016 | cyber_wolf
Darby, I'm not completely sure I understand. Juki machines have what is referred to as a multi-head. The offsets between the heads are the same as the spacing between 8mm feeders. So the (6) heads all come down at once and "gang pick" from 6 8mm fee
Electronics Forum | Mon Oct 03 13:37:40 EDT 2016 | chabscan
I've been having some problems with my Quad 4C, it rejects some components after having pikced them up. I want to adjust the tolerances and test the pick up. I want to know if there is some way of testing the pick up without having to run my whole
Electronics Forum | Sun Feb 13 16:28:00 EST 2011 | tpappano
Does nozzle #1 lower at all when it should pick up a part or is it just staying in the fully up position? If it does come down, but not quite far enough to contact the part, there are adjusting nuts on top of the head that set the lower limit for no
Electronics Forum | Sat Feb 12 18:35:56 EST 2011 | gabriel1blue
Thank you, that works perfect!! Now I was able to set up the offset's and program the machine, but now head #1 will move to the feeder location but it will not move down to pick up the part, then it moves to the drop area, but its only happening on h
