Electronics Forum | Mon Oct 03 13:37:40 EDT 2016 | chabscan
I've been having some problems with my Quad 4C, it rejects some components after having pikced them up. I want to adjust the tolerances and test the pick up. I want to know if there is some way of testing the pick up without having to run my whole
Electronics Forum | Mon Aug 25 11:43:30 EDT 2014 | fuji_user_2014
Looking for information on how to stop our Fuji from picking up parts in advance for the next board at the in carrier. In other words, how can we stop the machine from picking up parts before reading fiducials on a board without adding a skip mark t
Electronics Forum | Thu May 05 19:13:33 EDT 2016 | darby
Thanks Sr. If you have zero tolerance for simul pick up in your component files then you will not have simul pick up due to variances in your head offsets. So you are saying that on your Juki you run a tolerance for 0201? All other head positions at
Electronics Forum | Wed Aug 27 16:08:51 EDT 2014 | fuji_user_2014
Alright, thanks for the fast reply
Electronics Forum | Wed Aug 27 13:49:02 EDT 2014 | jimmyboz
In that case, please consider one block skip mark, the same first sequence for all programs, view some feature of the X-Y table, not the PCB, that way, its just a habit. I will look into preventing advance pick, not sure if it is possible.
Electronics Forum | Thu May 05 07:58:35 EDT 2016 | cyber_wolf
Not sure what you mean. 0201's and 0402's are both on 8mm feeders. Juki's will do simultaneous picks an all 8mm feeders no matter the component size. Your feeders need to be maintenanced and calibrated to reliably pick 0402's and 0201's. I hav
Electronics Forum | Tue Aug 26 09:13:34 EDT 2014 | fuji_user_2014
Thank you, but as I said before, is there a way to do this WITHOUT adding skip marks? We need a global setting that will affect all our existing programs.
Electronics Forum | Wed Aug 27 13:59:10 EDT 2014 | jimmyboz
Or else, as Dman may have been pointing to, duplicate the first fid sequence, and use it as the block skip mark, if found, then the next sequence is the fid it already found as a block skip mark....
Electronics Forum | Thu May 05 01:50:44 EDT 2016 | darby
Dear Forumites, It's been a while, but I have a question. I was recently asked to provide a scenario on capacity if we retired two older lines and replaced with a new line. My capacity figures were based on real time production over a period of six
Electronics Forum | Mon Aug 25 16:14:59 EDT 2014 | dman97
In Fuji flexa, under the machine configuration tab. Panel and Board mark reading order should be set to SKIP MARK. (this only works if you have the skip mark active in your fiducial list)If it is set to FIDUCIAL MARK, then the machine will ALWAYS pic