Electronics Forum | Tue Sep 30 21:08:17 EDT 2003 | George
I just start training as operator of a Samsung CP-11E Pick-and-Place machine. I would like to know where to find info or tutorials about those machines or general info about "how smt pick-and-place machines work ". I have not found anything on the we
Electronics Forum | Wed Nov 24 06:24:52 EST 2004 | Joe
Hi, I am an Engineering student doing some research on the component/nozzle interface on SMT Pick and Place machines. Could anyone tell me the force at which the nozzle hits the component as it is picked from the feeder or the placement force on a
Electronics Forum | Tue Aug 02 11:17:27 EDT 2005 | Stefan
Tape feeders usually have a fixed pick position regardless of the package size. Is the component body off center in the tape pocket? I hope you can enter an offset in the feeder set up file. Also, perforation holes can deform, if the reel is too hea
Electronics Forum | Wed Dec 21 08:30:13 EST 2005 | jax
"aj" you should find your way to a training class. The measurement is from the zero point of the tray feeder( almost always the feeder slot pin giude that the center guide of the tray holder hits...located in the machine ). It is not the same as nest
Electronics Forum | Thu Mar 02 04:50:25 EST 2006 | bobpan
oh....for the feeders moving 2 parts....you must teach a pickup repeat. Make an extent in the pickup editor and attach it to repeat with pick and make it a 2x1 with an 80 mil offset. The machine will then pick the part that is out of the sensor first
Electronics Forum | Sun May 28 23:01:31 EDT 2006 | jacksaria
Hello to all, We are encountered many problems/defects in SMT lines.I would like to know your suggestion or recommendation for SMT optimization and improvement. What are the step by step solutions in order to optimized and to improve the printer, pi
Electronics Forum | Wed May 31 21:33:52 EDT 2006 | jacksaria
Hello jbrower, Thank you for the feedback. Actually, our main problems is the pick and throw. Whats your suggestion how to control the pick and throw?What are the factors that affecting pick and throw?How to reduce the sources of variance at each st
Electronics Forum | Thu Apr 12 20:27:28 EDT 2007 | stimpk
What is part vendor? Can you look that up and determine supply type etc tape/reel/bulk etc... Does it have a design/surface that a SMT nozzle can consistantly pick from? We place thousands of differents clips with ease. If your part can be picked and
Electronics Forum | Wed Aug 22 16:08:04 EDT 2007 | adtech
Hello All, I am trying to research pick and place machines for InP chips, and have only come across one manufacturer who has fabricated a pick and place that can handle small InP chips. Does anyone have other suggestions on Manufacturers specifical
Electronics Forum | Fri Aug 31 07:42:05 EDT 2007 | geb
Hi, This is for a Universal GSM1. Is there a way to make a nozzle rotate to the same point before picking the next component up. It is because we are trying to pick & place a rectangular component (Luxeon Rebels) with a rectangular nozzle. The nozzl
