Electronics Forum | Mon Mar 12 03:41:25 EDT 2007 | tanemmirt
i designed a new product; i want to produce it in china, so they requested the ICT to be done; i have 03 questions if some one can help me on: 1� is it mondatory to test all components and paths in the PCBA; and check all soldering joints? 2� testing
Electronics Forum | Tue Apr 03 05:20:42 EDT 2007 | Haris
HI I think it is matter of light which is throwing by ur Machine camera, Decrese its light level and then try i believe it may works, because camera only recognises its leads/pins as it reflects back & not the other things, or choose the ODD CHIP/ I
Electronics Forum | Thu Apr 05 09:18:14 EDT 2007 | pjc
Please note that pin holes and blow holes are not always defects. The latest IPC 610A Rev D workmanship standard has them as process indicators- depending on Class. I don't have the document handly while writing this. It would be good to look that up
Electronics Forum | Tue May 22 09:11:35 EDT 2007 | jola
Hi. We have changed our produktion from high volume to medium/low and have to start hunting change-over time. We have a lot of products with two sides and the settings of pins in the DEK 265 and Fuji QP242 machines when running b-side takes to long t
Electronics Forum | Tue Jul 24 10:57:12 EDT 2007 | babe7362000
Is there a reason why you want to wash the board > before wave?!?!? > > What is your process > flow? > > I run bottom side of my boards first, > then top just to make it easier to setup (easier > to put those support pins around those smaller
Electronics Forum | Mon Sep 10 11:00:11 EDT 2007 | mgrimes
Chris, Appreciate the response - we set FP to "1" last week but no help. The drift is only in the X as well - the Y is never off. We have tried switching the cards to see if if the problem goes to the Y but it doesn't - stays in the X. As for the b
Electronics Forum | Tue Oct 02 10:01:15 EDT 2007 | chrisgriffin
I once had a similar problem on a VIP98. The problem was with the FCU (furnace control unit). There was a burned IC on the lower left of the card. I don't remember what kind of part it was, only that it was very common and I got a new one from Dig
Electronics Forum | Mon Oct 22 10:54:48 EDT 2007 | mulder0990
What type of feeder storage carts do you use for your feeders? I have many of the Fuji CP-6 racks, but I have found the few Mossman Tebbs racks mor useful and safer for the feeders. I am constantly fixing damaged tape leaf covers from operators not
Electronics Forum | Thu Nov 08 00:01:57 EST 2007 | omidjuve
please download the picture from the link below . we have two picture . picture1 is the place of the 96 pin connector that we have problem with it and i should say that we use parallel & perpendicular direction for sending the board to the wave solde
Electronics Forum | Thu Nov 08 00:38:31 EST 2007 | omidjuve
please download the picture from the link below . we have two picture . picture1 is the place of the 96 pin connector that we have problem with it and i should say that we use parallel & perpendicular direction for sending the board to the wave solde