Electronics Forum | Wed Apr 02 09:45:25 EDT 2014 | swag
Not sure what kind of humidifier you are looking at but here's my experience: We have 4 humidifiers. All are ultrasonic supplied with DI water. They work well but... UT humidifiers will create a foggy white residue that will stick to things in cl
Electronics Forum | Thu Jul 31 14:52:38 EDT 2014 | rgduval
As I understand it, customized equipment for breaking the headers out can get fairly expensive. I've used two methods to do these, other than using cutters. First, we bought a bandsaw to use for cutting. The only disadvantage to using the bandsaw
Electronics Forum | Mon Oct 13 08:43:56 EDT 2014 | rob
Hi Larry, Picture a old lady with a set of knitting needles with leads attached to them, pressing the needles into different points of the PCB (pads, test points or component leads) and measuring resistance, inductance, waveforms etc between these p
Electronics Forum | Sun Oct 19 06:42:01 EDT 2014 | timbo292832
im designing a circuit that will require the use of a edge connector so it can connect to another circuit. i need to do this so i can get both micro controllers communicating i have done a bit of research and am thinking about using a pcb manufact
Electronics Forum | Fri Mar 06 07:15:38 EST 2015 | saoasasd
Hi, I have faced some problems with DQFN PACKAGE 132 PIN. After some cross sections and dye pry analysis we could find a head on pillow situation always on inner row pads. The PCBAs are double side and the DQFNs are assembled on Bottom side (Noteboo
Electronics Forum | Sat May 09 02:45:45 EDT 2015 | costas
Hi, I've bought a camera for video inspection ,Metcal VPI 1000 model. Price was reasonable. Unfortunately the light and video control box was missing. Now the light I can easily fix but I have no idea about the video part, I do not know the tasks for
Electronics Forum | Thu May 14 10:00:14 EDT 2015 | swag
I like MpM personally - run forever and programming is easy and leads you through it. It's hard to miss a step of programming with MpM software. DEK's a little harder (for me) but still very nice controls. The pluses of DEK - DEK has a high freque
Electronics Forum | Fri May 15 12:41:48 EDT 2015 | deanm
I chose a Vitronics XPM3i primarily for the AutoSet automatic profile generation feature. We are high mix and simply cannot profile every board. The AutoSet feature is quick, easy and we rely on it 100% and have great results. These ovens have had ve
Electronics Forum | Thu Jun 02 22:40:13 EDT 2016 | slouis2014
Hi, yes have a few experiments initially i tried to increase the solder volume but component pin have insufficient solder. 1. The solder coverage do you calculate it by solder volume or solder area. 2. if i would achieve as you recommend 50-60 % woul
Electronics Forum | Mon Jul 11 11:05:53 EDT 2016 | bradholland
thanks for the replies so far. So far I have been relying on the board clamp on the machine that closes when the pwb is loaded. I have also been doing these tests with double sided tape on the pwb so i can clean them off easier afterwards. I have
.gif)
