Electronics Forum | Thu Oct 13 14:14:10 EDT 2005 | rcanten
It depends on the type of connector but if you have a connector that has projections on the ends that look similar to leads in the lighting you will be hard pressed to get this to place with anything other than a vision number 6 on a IP2 and then the
Electronics Forum | Thu Oct 13 10:51:26 EDT 2005 | djshure
Hello. I'm wondering if anyone out there is working with prototyping 201 sized componants. I'm curious to know about the tools you like to use. I am quite comfortable placing 402's alld ay long with a simple soldering iron, but i'm concerned that i w
Electronics Forum | Thu Oct 20 09:07:05 EDT 2005 | Mike
Hello, we are evaluating to purchase a new machine for our smt production. Our current favourites are Samsung SM320 or Yamaha/iPulse M4e Please let me know what you think about those machines. Best Regards Mike
Electronics Forum | Mon Oct 24 11:00:11 EDT 2005 | rlackey
You can't really use a pasted board to troubleshoot the program as any components not on target simply slide off with machine vibration and movement as they won't be held by the solder paste. Whereas on double sided sticky tape they remain in place
Electronics Forum | Mon Oct 31 14:50:15 EST 2005 | frodriguez
Hi There. I use to suffer the same pain,specially when i had limited board quantities. You can use an antiestatic transparency attached to the board using Kapton Tape,than place the double sticky tape. This work perfect,kapton tape residues clean ve
Electronics Forum | Wed Dec 07 11:58:36 EST 2005 | derengmao
Could you help to tell what is the way to pick/place 0402/0201 using QSA30? Also do you know that without a VME bus Control B/D (illumination card for fixed camera), the new version software (ver.6.0 and above) will not initialize the vision system.
Electronics Forum | Mon Jul 17 13:36:55 EDT 2006 | kjeffries
I appreciate your comments regarding the programmability of the Mirtec. What type of SMT machine do you use? How easy have you found it to transfer the SMT profiles to the Mirtec? How do you rate the Mirtec in handling top/bottom, multi-panel asse
Electronics Forum | Tue Oct 25 22:50:16 EDT 2005 | KEN
What is the (initial position) ratio of pulse counts to home encoder pulse (relative to the home sensor). It should be 50% +/- 15% Run this test several times in between a warm up. I bet your numbers are all over the place. I bet you have a loos
Electronics Forum | Tue Nov 01 09:57:18 EST 2005 | Chris
Hi, I am experiencing cracked solder joints on ceramic resonators after the ultrasonic plastic weld process. PCB assy is placed into plastic housing and then housing halves are ultrasonic welded. Not a soldering problem. I know this component is
Electronics Forum | Tue Nov 01 20:48:53 EST 2005 | erokc
I am forced to use fine pitch parts in a new design. Board alignment in production has to be addressed. Fudicals, where to place, shape, size. I'm assuming they must be in the copper to represent the pad positions. Are they placement machine depe