Electronics Forum | Thu Jun 06 07:53:51 EDT 2002 | Jim M.
Has anyone had much luck Picking and Placing die with a Panasonic MPA-G3?What special setups or considerations are required? Currently we pick and place one die with our Universal GSM using only one nozzle. The nozzle must be painted white in order
Electronics Forum | Fri Feb 16 11:07:25 EST 2007 | stepheniii
I'm not sure if anyone mentioned the single most important factor. p.m.'s. If the nozzles are getting dirty and clogged it's not going to do a great job of picking parts up. Don't think in terms of variation. It's there it's unavoidable and undet
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.
Electronics Forum | Thu Feb 18 14:42:38 EST 2010 | djsmith1000
Hi everyone, First post here. I am completely new to smt as well. We are a small startup and would like improve our in-house smt assembly capability from manual assembly. We are looking at small production runs, initially about a total of 200 board
Electronics Forum | Sun Sep 05 03:52:11 EDT 1999 | Brian
| We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong