Electronics Forum | Thu Mar 10 15:13:31 EST 2005 | pmd
I agree with SirTec. Conflicts with other magazines slotted into machine often cause un reckognized magazine errors elseware. You can also try to re seat the first pair of MOT driver cards in computer this is whare mag data is stored. Also a loose ca
Electronics Forum | Thu Mar 10 15:04:40 EST 2005 | pmd
Rapid heating of solder caused solder underneath surface to expand and become pressurized. Check to see if power cycles on and off during warm up. A slower rate of of climb should help.
Electronics Forum | Thu Mar 10 23:23:56 EST 2005 | pmd
We have a MyData TP-9-2 with a in line Y wagon. It is a long screw and the vintage is 1994. The Y wagon vibrates at about 24 micrometers at about 25 hertz. Burnin reviels zero encoder pulse errors. Hystersis test indicates a Y axis Y wise varance of
Electronics Forum | Wed Mar 16 17:43:33 EST 2005 | pmd
We grease acording to PM schedule. The cable is very old about 5 years. We run 2 shifts. The transducer program and burnin test show the varance that we are seeing phisically so I can rule out the transducer. The motor may be the cause as it is of 19
Electronics Forum | Wed Mar 23 23:00:17 EST 2005 | pmd
Problem solved. Thru the help of MyData support we have determined that older MyDatas have a software issue with the servo drivers. A newer rev of driver will fix this problem.
Electronics Forum | Fri Mar 18 14:27:29 EST 2005 | pmd
Hold on, MyData can place no component and not detect error if the minimum and maximinum settings in the centering phase are within the mesurement of the tool it'self. Especially if the levels are down between the jaws. For insurance make sure the to
Electronics Forum | Wed Mar 16 17:34:20 EST 2005 | pmd
decrease pump rpm, for penitration try tweeking pitch as well as belt speed. On the delta wave spray pitch and belt speed are related.
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are
Electronics Forum | Fri Mar 18 18:59:03 EST 2005 | pmd
Sorry I was not familiar with the SPM machine, Disreguard previous response that I sent.
Electronics Forum | Fri Mar 18 14:32:43 EST 2005 | pmd
Im not fimiluar with SIEMENS F5 but I believe that lead length devations translate to coplnary devations. As a lead gets bent inward or outward the coplnary changes. I dont know what the ratio is but you may be able to set tolorances for lead length
.gif)
