Electronics Forum: position (Page 1 of 177)

MPM prestop position

Electronics Forum | Tue Jul 05 05:23:34 EDT 2005 | kentes

We have one set MPM AP25. Its prestop position is not stable,but stop position is stable. It often occur "time out" alarm when load PCB.Which one can help us.

Cp6 mark read position

Electronics Forum | Sat Aug 22 09:59:44 EDT 2015 | linux

Hello all, Can someone tell me the step by step procedure to check xo,yo, mark read position using Fuji board. Cp6 Fuji.

MPM prestop position

Electronics Forum | Wed Jul 06 10:22:04 EDT 2005 | PWH

At times we have had this problem with our AP25 due to one of the conveyor belts slipping. Load a PCB and check to see that both conveyor belts are running at the same speed. If not, tighten the one that is dragging. Hope this helps.

MPM prestop position

Electronics Forum | Thu Jul 07 08:29:51 EDT 2005 | chunks

Check to make sure your conveyors are parallel. Also verify the the width to make sure the belts are supporting the board properly. Sounds funny, but I see this more times than anything else.

MPM prestop position

Electronics Forum | Thu Jul 07 09:53:17 EDT 2005 | PWH

Agree with D.B. We have also had to replace the belt that runs the auto conveyor width function. It might look just fine, but it will skip teeth on occasion if stretched or worn. Reparallelling the conveyor rails can be done manually by skipping t

Entering placement position on GSM's

Electronics Forum | Sun Feb 11 12:12:48 EST 2007 | dilogic

Just out of curiosity - is it possible to enter placement positions in interactive mode (using camera image) on the GSM1 series? - Deni

Entering placement position on GSM's

Electronics Forum | Mon Feb 12 08:28:20 EST 2007 | dwelch

I have two gsm1's and I don't believe the current software can do this. Assuming you are not importing cad data, that would be the only way.

Entering placement position on GSM's

Electronics Forum | Mon Feb 12 09:44:47 EST 2007 | SWAG

Enhanced board set-up, set conveyor width, load board, (your fiducials must be accurate!), use two fiducials to set reference point, click on placement(s), move crosshair to centerpoint, use two point teach to teach one point in the center or use cor

MyData and their position on used equipment.

Electronics Forum | lysik |

Wed Jul 10 21:11:57 EDT 2002

zevatech 570 Driver Error KNOCK position E7018

Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub

Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had

  1 2 3 4 5 6 7 8 9 10 Next

position searches for Companies, Equipment, Machines, Suppliers & Information

SMT spare parts - Qinyi Electronics

Wave Soldering 101 Training Course
Selective soldering solutions with Jade soldering machine

High Throughput Reflow Oven
Pillarhouse USA for Selective Soldering Needs

High Precision Fluid Dispensers