Electronics Forum | Mon Feb 28 08:34:46 EST 2005 | Alex
Good advises thanks. I'll go thru all nozzles and vacuum check today and tell the programer about PD's and nozzle vs shutter. Should I check at the same time all the vacuum filter ? For the placement test, we use the same feeder at the same position.
Electronics Forum | Mon Mar 14 08:35:27 EST 2005 | ???
no...its losing its position and it homes ok so the sensor is not the problem.....there is a mod code that sets the illumination level for the quad align....make sure that is at 200 or higher. You may want to change the qa card if you have another on
Electronics Forum | Wed Apr 13 21:04:39 EDT 2005 | pdeuel
We have a controlled pressure facility. When the pressure is set at 0.2 lbs above outside our security doors that open outward do not close by themselvs causing alarms. Our facility remains dusty under and on equipment because of conditions listed on
Electronics Forum | Thu Apr 28 01:30:07 EDT 2005 | Marv
The Tray wagon on a Mydata can be any table width you desire, a one bay holds two trays, a two bay holds five, and a three bay holds seven. The tray wagon can be removed in about a minute flat. the TEX actually only requires two slot positions to h
Electronics Forum | Mon Jun 20 18:36:42 EDT 2005 | jsloot
Does anyone have any experience with a QUAD Meridian 1010? Our company has purchased a used machine. We have it installed and running almost smoothly. Getting an error code 3487, description is "Z axis target position in motion board is strange" Anyo
Electronics Forum | Thu Jun 23 10:36:04 EDT 2005 | stepheniii
I think the single most important thing will be to maintain positive pressure in the room. All the air filtering will not be able to keep up if dirt is blown into the room everytime a door is opened. The next would be to control as much as possible,
Electronics Forum | Thu Jun 23 12:59:09 EDT 2005 | jdumont
That was a great article. Luckily for us we dont build at the wafer level. Only PCB assembly through surface mount and wave. I like the positive pressure idea. Im going to contact the HVAC guy and see what he thinks. I think that just being in a clos
Electronics Forum | Wed Jun 29 19:33:12 EDT 2005 | matjen
After the machine stops for any reason when restarted the z table goes to loader position comes up then goes back down and re-reads the fiducials, only one machine does this but we are losing valuable cycle time after every part change. We have Fuji
Electronics Forum | Fri Jul 08 10:11:44 EDT 2005 | Luke Mittur
Hello When the table goes back to loading position, it checks for the avaialbility of the board. It is possible that there is a component right under the PCB confirm sensor and the sensor is not able to recognise the board, so it unclamps . No
Electronics Forum | Tue Jul 19 12:03:34 EDT 2005 | cyber_wolf
CLampron, There is no place for PCB thickness in a Mydata program. The board thickness is of no consequence.(As long as the thickness is uniform across the entire board) When you run a program, the Z axis touches the surface of the board to determin