Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty
Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic
Electronics Forum | Tue Nov 15 12:24:12 EST 2011 | nevercry14
Well try to run in idle n as soon as the mtu. Goes to pick up part on tray it goes down but when homing back in position doesnt flag sensor because position is off.so the sz sensor not bieng flaged. Any ideas
Electronics Forum | Mon Dec 19 15:39:23 EST 2011 | carlparks
When we initiaize the machine we get an error. Axes:Z Required Position: 15000 Current Position: -228
Electronics Forum | Tue Apr 03 06:08:11 EDT 2012 | rpa
Hi, where can i place a manual tray feeder on OPAL XII - Assembleon. I tried to put the tray on rear side feeders positions and teached components array positions but an error occurred "software outlimits".
Electronics Forum | Wed Nov 20 10:02:54 EST 2013 | dekhead
R)... This will be primarily seen in the "Y" direction with minimal effect in "X". It is possible that one of the chase rails is not locked (spring-loaded lock on rear), and changing position during screen load. http://www.dekhead.com
Electronics Forum | Sat Jul 26 12:37:10 EDT 2014 | jimmyboz
In the future, please try to explain the situation with some detail. Usually this is the sensor on the 10th station to verify to nozzles are in the up position.
Electronics Forum | Tue Feb 24 08:41:42 EST 2015 | leeg
We are getting a position board system error more and more just lately on a FX1 that we have, anyone seen this error before ?
Electronics Forum | Sat Oct 10 02:59:53 EDT 2015 | aemery
AVCOM, I have worked on a few of the Conceptronic ovens recently for one of my clients. They had a similar issue, all the heaters dropping out with a high temp circuit error which kicks out CON1 (Heater power). If you're saying what I think your sa
Electronics Forum | Tue Jul 26 09:48:44 EDT 2016 | leeg
Have you taught the tray position in correctly, I dont know that particular machine but you normally teach in 3 positions. When you have done this have you re-optimised?
Electronics Forum | Sat Feb 16 11:36:09 EST 2019 | robertorocco
When the camera moves to the bord stop position, or to the fiducial position, the following message appears "Axis camera error - out of time" some indication on how to solve the problem? Thanks