Electronics Forum | Thu Jul 31 03:20:29 EDT 2008 | miroyu
Hi everyone I have Quad 4C with following problem. When I run machine "cold start" first power up it will run and initialize but after if I turn it off and back on it will NOT initialize. Z axis will push nozzle down and it will remain i that posit
Electronics Forum | Thu Aug 21 19:18:47 EDT 2008 | duchoang
My steps are different in that case: 1- Check mounts. Try to adjust origin point until get the pretty good mount positions. 2- Teach fiducials ( Board fids, not panel fids) 3- Use fids, check mount again. 4- If OK, then teach Block Repeat. This alwas
Electronics Forum | Fri Sep 26 08:11:15 EDT 2008 | dwelch123
Try swapping cards in Y1 enclosure. You can swap zero and one or two and three but make sure you change the shunt position and the dip switch settings and see if your problem switches cards. The lithium battery likes to fail on those cards. Reload th
Electronics Forum | Mon Oct 27 01:57:12 EDT 2008 | benefon
Hi It appears as if the clincher is not perfectly centered even if it does appear so. You can try to adjust the clincher offset values by entering trial values for the X and Y offsets. Try changing these values in both positive and negative directio
Electronics Forum | Wed Dec 03 15:10:37 EST 2008 | evtimov
Hi, we also use Advantis machines. Our software have a software option "Auto teach pick up position". This one is made exactly for not perfect feeders or reels. In case you have this option it could help you. you can set it for each part you want.
Electronics Forum | Tue Mar 10 11:39:10 EDT 2009 | bobpan
Craig, Try this.... Go into 'machine-calibration-transport' then click on 'touch stop'. Reteach your board touch stop x for both gantries (if you moved both touch stops). If the board still does not reach the touch stop.....teach 'Board Positioning S
Electronics Forum | Thu Mar 12 13:20:07 EDT 2009 | ck_the_flip
Before anyone tells me to search the fine archives, I already did! I typed Sn100c and Reflow, and nothing came up. Anyway, any of your folks out there run Sn100C across the board - Reflow, Wave and/or Selective, and Hand-Soldering? If so, please p
Electronics Forum | Tue Mar 31 15:14:53 EDT 2009 | kpm135
Is your machine an inline system with the conveyors along the back? If so I have run into this problem before with the sensors on the covers for the conveyors. They are 'magnetic' safety switches that can appear to be closed but don't actually switch
Electronics Forum | Wed Apr 08 04:29:14 EDT 2009 | kircchoffs
Hi Rodrigo, is your problem occurs only at 2nd device table? how about if you transfer the feeders to the 1st device table? if it happens at both device pls your part data if there's a value at pick-up. you can also check the proper data of the de
Electronics Forum | Fri Jul 31 10:02:12 EDT 2009 | spitkis2
Thanks for the info. On the Mydata do you position the cut tape inside a feeder or place it on a tray of some sort? Here the environment is OEM R&D lab so a Mydata would be overkill in terms of size and cost. I was thinking of a smaller auto pick