Electronics Forum: post placement aoi (Page 1 of 49)

aoi

Electronics Forum | Mon Sep 23 21:44:49 EDT 2002 | davef

Commercial postings The level of commerce in the following two threads is way out of hand: * �Where Do I Start?� http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=5491&mc=38 * This thread �AOI� Please stop!!!

aoi

Electronics Forum | Thu Sep 19 16:58:04 EDT 2002 | dragonslayr

You definitely need to have live demos of each system, using your specific assembly if you want to compare apples to apples. Each of the AOI OEM's you mentioned have plus amd minus to their unique systems. You will need to evaluate your specific nee

aoi

Electronics Forum | Fri Sep 20 14:23:50 EDT 2002 | larryk

PizzaFred, Scott mentioned lots of good ideas. Take one of your boards to each vendor and see what it takes to program the board how long it takes for it to become online. I've found some that are easy to program, but require 40 or more assemblies to

aoi

Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske

In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t

aoi inline

Electronics Forum | Thu Aug 23 21:00:10 EDT 2001 | davef

We do the same quadrent every four boards in placement inspection on a Orbotech.

aoi inline

Electronics Forum | Tue Aug 21 21:11:29 EDT 2001 | davef

It depends on what you're doing. Say for component placement verification, a line that's kicking-butt might have time to look at a somewhat different quarter of each board, depending on lots of stuff [eg, board, AOI equipment, line rate, etc.]

aoi inline

Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker

Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of

Densipak placement

Electronics Forum | Wed Oct 25 02:09:43 EDT 2000 | keith_hodgson

We are using a Universal GSM to place Densipaks.Unfortunateley every so often we hit a spell were the Densipak is raised because either one or both of the locating posts on the Densipak has not located correctly in the hole. These are very hard to re

Line release of post reflow AOI and AXI

Electronics Forum | Tue Sep 16 15:47:05 EDT 2008 | ismir

Hello everyone! I'm a student of electrical engineering currently working on a thesis for my BSc degree. It will be about post reflow AOIs and AXIs, and I'd kindly like to ask you for some help with it. I would like to know if there are any standar

Line release of post reflow AOI and AXI

Electronics Forum | Tue Sep 16 19:16:11 EDT 2008 | hegemon

Hello everyone! > > I'm a student of electrical > engineering currently working on a thesis for my > BSc degree. It will be about post reflow AOIs and > AXIs, and I'd kindly like to ask you for some > help with it. > > I would like to know if t

  1 2 3 4 5 6 7 8 9 10 Next

post placement aoi searches for Companies, Equipment, Machines, Suppliers & Information