Electronics Forum | Tue Oct 11 22:58:19 EDT 2005 | KEN
Isn't it funny how solder manufacturers are adopting a spec. limit of "not to exceed 1000ppm of lead content". Doesn't leave much room for the rest of the "process".
Electronics Forum | Fri Oct 14 04:00:05 EDT 2005 | steve
Your friendly wave guy here, check out Aim solders web site. click to the right where it says lead free. There is a complete discussion on what can occur. http://www.aimsolder.com
Electronics Forum | Tue Mar 01 22:20:59 EST 2005 | davef
Marc: You say, "Copper will sink to the bottom of a pot since it is lighter ..." Why does it sink if it's lighter? What is copper lighter than?
Electronics Forum | Sat Mar 19 11:31:51 EST 2005 | fastek
Electrovert provides a lead free retro fit kit for your Econopak Gold machine...as long as you have a cast iron solder pot. $10K-$12K for the kit.
Electronics Forum | Sun Apr 17 09:35:33 EDT 2005 | ozgur.varol@basari.com.tr
I have one of these too and � have manuals about jot conveyour but my conveyour has a pot for adjust the speed � can send conveyour's electrical schmatic to you as a jpeg format
Electronics Forum | Fri May 20 10:11:50 EDT 2005 | davef
Emerson Ventilation Products 10048 Industrial Boulevard Lenexa, KS 66215-1219 Phone: 913-752-6000 Fax: 913-752-6478 http://www.emersonvent.com
Electronics Forum | Thu May 26 13:04:44 EDT 2005 | c111
Can anyone recomend tools for cleaning & adjusting of a lead free solder pot? I know it's not recomended to use the standard stainless tools. I was told by an FSE to use wood (kitchen) tools. Thanks
Electronics Forum | Tue May 31 22:55:08 EDT 2005 | davef
We think it will make little difference to your customer. It really depends on your customer's end-use environment though. Tough to guess. In a short time, both of pots will be "SAC" though.
Electronics Forum | Thu Jun 23 00:28:42 EDT 2005 | KEN
....how does the part perform in a wetting test. Is it solderable on a bench or dip-plating in a pot? If you add flux and heat can you fix your problem assemblies? If yes, plating finish or substrate is not your problem. What flux are you using?
Electronics Forum | Mon Aug 01 08:38:57 EDT 2005 | kamrant
Joseph, What is the topside temp reading of your board before reaching the pot? Do you have top-heater in your wave machine? It sounds like; you got an insufficient per-heating issue.
