Electronics Forum: power and cyclone (Page 1 of 7)

CP4 jerks all axis after power up and reset sw...

Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo

Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all

CP4 jerks all axis after power up and reset sw...

Electronics Forum | Thu Apr 12 15:21:12 EDT 2012 | jdengler

Have you tried to do a reset start? When Fuji's act weird the first place to start is a reset start, then re-load the Proper Status and Program. Jerry

CP4 jerks all axis after power up and reset sw...

Electronics Forum | Mon Apr 16 10:48:58 EDT 2012 | cyber_wolf

Sounds like a bad or out of adjustment servo amp.....

CP4 jerks all axis after power up and reset sw...

Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo

I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi

CP4 jerks all axis after power up and reset sw...

Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler

Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu

CP4 jerks all axis after power up and reset sw...

Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo

Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset

new to circuit boards trying to figure out where to connect positive and negative power to wireless transmitter

Electronics Forum | Mon Jan 30 10:01:07 EST 2017 | smduke

Hello and thanks in advance. I am new to this stuff, I bought a wireless transmitter receiver and am wondering how to connect the power source, a buzzer to the receiver and a led light to the receiver. attached is a screen shot of what I have and wh

new to circuit boards trying to figure out where to connect positive and negative power to wireless transmitter

Electronics Forum | Mon Jan 30 12:35:31 EST 2017 | davef

Look here: http://arduinobasics.blogspot.com/2014/06/433-mhz-rf-module-with-arduino-tutorial.html

new to circuit boards trying to figure out where to connect positive and negative power to wireless transmitter

Electronics Forum | Thu Feb 02 16:59:54 EST 2017 | smduke

thank you, that will help. I also purchased a beginner kit so I can learn how to use this stuff.

0201 and uBGA

Electronics Forum | Wed Sep 25 13:38:35 EDT 2002 | finepitch

Yannick, If we leave the 201 issue aside; have you checked where those BGA pads are connected to? Could those be power/ground balls connected to large (difficult to heat up) planes by any chance? Erhan

  1 2 3 4 5 6 7 Next

power and cyclone searches for Companies, Equipment, Machines, Suppliers & Information