Electronics Forum: powerpak so-8 (Page 1 of 1)

Reflowing a PowerPak SO-8

Electronics Forum | Wed Nov 05 08:24:16 EST 2003 | Paul O ' Connor

When reflowing a Vishay PowerPak SO-8 & using the recommended footprint from the data sheet, the component is skewing in reflow, to solve this we have to add a glue dot to both sides of the part, will making the PCB land pad 1:1 with the Solderable

Reflowing a PowerPak SO-8

Electronics Forum | Wed Nov 05 08:49:39 EST 2003 | Axl

You might want to try reducing your stencil aperture by 10% first off; if it still swims try using a home plate design. Also if your profile is going into liquidous to fast, this might cause the swimming as well, check your profile.

Reflowing a PowerPak SO-8

Electronics Forum | Thu Nov 06 07:54:50 EST 2003 | davef

First, skewing is a perfectly acceptable condition, providing the amount of skewing is not excessive. A-610 provides guidance. Second, this part is a land grid device. Land grid devices [ie, BCC�, LGA, QFN, MicroLeadFrame�, etc] are essentially BGA

  1  

powerpak so-8 searches for Companies, Equipment, Machines, Suppliers & Information

One stop service for all SMT and PCB needs

Training online, at your facility, or at one of our worldwide training centers"
SMT feeders

High Resolution Fast Speed Industrial Cameras.
thru hole soldering and selective soldering needs

High Throughput Reflow Oven
PCB Depanelizers

Low-cost, self-paced, online training on electronics manufacturing fundamentals