Electronics Forum | Sat Jan 19 02:29:11 EST 2002 | ianchan
Thanks for the tips... found out the ex-employee guy, had pre-bake conditioning put into the process flow, as this pcb is made of polymide material, that is reputed to have historical patterns in thermal sensitivity. To avoid "thermal damaging" the
Electronics Forum | Thu Jan 17 20:33:05 EST 2002 | ianchan
Hi, Can anyone help explain the benefits/disadvantages of bareboard pcb baking, as part of the pre-heat conditioning, before the bareboard pcb use in SMT production run? The pcb board is 200mm x 240mm panelized pcb board, and has 28 smaller pcb boa
Electronics Forum | Fri Jan 18 04:45:32 EST 2002 | wbu
Ianchan, baking as being part of pre-heating is obviously sensless cause the PCB will not maintain any of that heat till soldering. Common reason for prebaking PCB�s is getting the moisture out to prevent outgassing, warpage and maybe other defects.
Electronics Forum | Thu Aug 09 09:05:09 EDT 2007 | davef
There are no requirements acceptance criteria for baking of board assemblies. What are your customer requirements? The common reasons people choose to bake PCB are to prevent: * Delamination of multilayer boards * Measles, particularly on double si
Electronics Forum | Fri Jan 05 20:12:22 EST 2007 | engr
I am using PWB material Rogers 6002 High Frequency Laminate. The PWBs are assembled. They were washed and will require a bake out. Some people say, no bake out is required for the material. I am getting different reads in test if the CCAs are not
Electronics Forum | Wed Dec 22 18:09:07 EST 2004 | kmorris
At a previous job I had been taught that when reflow soldering polyimide flex circuits, it was necessary to pre-bake them before reflow soldering to prevent delamination. Our procedures said that there must be a 1hr bake prior to reflow, and the flex
Electronics Forum | Tue Feb 03 11:33:08 EST 2009 | nath
Hello, Can anyone list out issues or concerns with assembly with PTFE based laminates. I am looking for any concerns related to handling, SMT reflow, Wave, Baking, rework, BGAs? ANy feedback is much appreciated. Thanks!
Electronics Forum | Tue Feb 03 16:23:40 EST 2009 | gnath
Hello, Can anyone list out issues or concerns with assembly with PTFE based laminates. I am looking for any concerns related to handling, SMT reflow, Wave, Baking, rework, BGAs? ANy feedback is much appreciated. Thanks!
Electronics Forum | Wed Dec 22 19:09:17 EST 2004 | rohman23
Very strange...I just logged into the internet to come post this very question for all the lurking experts. We have a 16 layer rigid-flex that we have never baked. Our board vendor is expressing concern that we do not perform a pre-bake before assy
Electronics Forum | Thu Dec 09 08:29:19 EST 1999 | Charmaine Bode
Excuse my ignorance. Please advise whether it is advisable to pre-bake boards before assembly. Thanks Charmaine
