Electronics Forum | Wed Feb 02 21:17:55 EST 2000 | Steve Harshbarger
Istvan, The advise from both Roni and Mike sounds right on the money. The problem is most likely that your PCB is not completely dry (the flux has not completely evaporated) in the area where these solder balls occur. You have a number of differen
Electronics Forum | Fri Dec 17 03:38:53 EST 1999 | cklau
Hello Guys; I "ll like to add some comment on Mr John message , see below.. "Be sure that the components to be used on the bottom can take the maximum heat of the wave and the delta T of entering the wave."-John The required preheat temp , that i
Electronics Forum | Thu Dec 16 16:46:47 EST 1999 | Mike Naddra
Steve , I use a general set of guidlines when developing reflow profiles: Ramp rate to 140 deg C - 50-60 seconds Time at preheat (140-160 deg C) - 90-120 sec Time above liquidous (183 deg C) - 45-90 sec Time at peak (215-225 deg C) - 9-12 sec peak t
Electronics Forum | Tue Sep 07 12:51:02 EDT 1999 | Brad Kendall
| | We are assembling double side pcs reflowing (smt) on top and by wave on bottom. | | After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. | | After wave so
Electronics Forum | Tue Jun 15 04:55:00 EDT 1999 | Brian Ellis
The other answers on this thread are realistic but it also depends: a) on the quality and finish of the components and PCB (including, of course, solderability) b) the flux type (I would expect lower defect rates with water-soluble than with the less
Electronics Forum | Wed May 26 13:30:58 EDT 1999 | JohnW
| we have just started wave soldering passive SMT components and through hole. We are having trouble with voids on the SMT components. It is very random, but effects a lot of TSOT's. We are using an electrovert with a chip wave. Are there any obv
Electronics Forum | Wed May 26 14:24:13 EDT 1999 | Boca
| | we have just started wave soldering passive SMT components and through hole. We are having trouble with voids on the SMT components. It is very random, but effects a lot of TSOT's. We are using an electrovert with a chip wave. Are there any o
Electronics Forum | Wed May 12 17:37:08 EDT 1999 | Timothy O'Neill
| I am looking for anyone who has converted over to VOC Free flux. I need some info on any problems, etc. that you might have had. | | Please E-mail me at wes.ruggles@vickers-systems.com or call at (513) 494-5229 | | Thanks | Wes Ruggles | Hi Wes
Electronics Forum | Sat Mar 06 08:01:45 EST 1999 | Scott Cook
| Can someone please advise me to the rework procedure for removal and replacing Ceramic Chip Capacitors (e.g. 0805, 1206, etc.)? | | Is it necessary to pre-heat ceramic capacitors before soldering them onto a PCB with a soldering iron? Is this just
Electronics Forum | Mon Nov 23 19:34:51 EST 1998 | Mike Demos
Charles: Here are a few possibilities you might want to check: 1) Conveyor width -- if the conveyor is too tight this will cause the boards to buckle as they go through the preheat section. We recently had this happen when we changed operators. 2
