Electronics Forum: press fit (Page 1 of 14)

Press for press fit connectors

Electronics Forum | Mon Oct 25 16:53:57 EDT 1999 | Mario

Hi, Does anybody know where I could get a cheap but efficient press for press fit connectors (200pins and up)? Pneumatic or Hand lever Mario

Re: Press for press fit connectors

Electronics Forum | Mon Oct 25 17:06:18 EDT 1999 | William

Mario, If you are looking for a cheap press to do press fit connectors, then you are asking for trouble. Now, and in the long run. ASG out of West Palm Beach makes a very good press. We bought a 5 ton version and are able to press up to about 2500

press fit on Ni/Au board finish

Electronics Forum | Thu Apr 18 14:00:35 EDT 2002 | Romain

Is anyone has experience on problems with press-fit on Ni/Au board finish. Connectors pins are SnPb finished. I am particulary interested by experiences or documentation in very agressive environmental conditions (avionics or space buisness) Thanks r

Re: Press for press fit connectors

Electronics Forum | Tue Oct 26 10:23:58 EDT 1999 | Arthur

Mario You can reach ASG at PH: 561-848-6746

press fit on Ni/Au board finish

Electronics Forum | Thu Apr 18 16:52:15 EDT 2002 | davef

General comments are: * First place I would look is the supplier of the pins that you are trying to install. Most suppliers that sell press fit components have done a good deal of work to qualify the component and will have all the specifications yo

press fit on Ni/Au board finish

Electronics Forum | Mon Apr 29 03:16:43 EDT 2002 | Bob Willis

I have only seem problems so I would suggest you don't do it.

Re: Press for press fit connectors

Electronics Forum | Mon Oct 25 19:29:12 EDT 1999 | g cronin

hi mario there is a company called motion automated that makes a nifty press, i have one in my shop that i have used for a while. well built and they have been able to make me custom tooling as well at reasonable prices. i'm going to try to dig u

press fit on Ni/Au board finish

Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan

Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati

press fitting connector

Electronics Forum | Tue May 28 11:36:46 EDT 2002 | floydl

Hello Jim, Is any special tooling required for press-fitting a connector?

Press fit parts help

Electronics Forum | Tue Oct 14 08:27:32 EDT 2014 | kkay

We use a few different style of press fit connectors, terminals, studs, etc. We use a tabletop arbor press for most everything we do, but a lot of times we will see some measling or slight delamination around the holes for the press fit part. Is ther

  1 2 3 4 5 6 7 8 9 10 Next

press fit searches for Companies, Equipment, Machines, Suppliers & Information