Electronics Forum: press fit fixture (Page 1 of 17)

Re: Press for press fit connectors

Electronics Forum | Mon Oct 25 17:06:18 EDT 1999 | William

Mario, If you are looking for a cheap press to do press fit connectors, then you are asking for trouble. Now, and in the long run. ASG out of West Palm Beach makes a very good press. We bought a 5 ton version and are able to press up to about 2500

Press for press fit connectors

Electronics Forum | Mon Oct 25 16:53:57 EDT 1999 | Mario

Hi, Does anybody know where I could get a cheap but efficient press for press fit connectors (200pins and up)? Pneumatic or Hand lever Mario

Press fit parts help

Electronics Forum | Wed Oct 15 03:59:00 EDT 2014 | rob

Are you using specific tooling for each part, or just generic? If so it could be pushing down at an angle and slightly tearing the PCB. We use the same style press as you but make custom fixtures to fit each connector and hold each PCB tight.

Re: Press for press fit connectors

Electronics Forum | Tue Oct 26 10:23:58 EDT 1999 | Arthur

Mario You can reach ASG at PH: 561-848-6746

press fit on Ni/Au board finish

Electronics Forum | Thu Apr 18 14:00:35 EDT 2002 | Romain

Is anyone has experience on problems with press-fit on Ni/Au board finish. Connectors pins are SnPb finished. I am particulary interested by experiences or documentation in very agressive environmental conditions (avionics or space buisness) Thanks r

press fit on Ni/Au board finish

Electronics Forum | Thu Apr 18 16:52:15 EDT 2002 | davef

General comments are: * First place I would look is the supplier of the pins that you are trying to install. Most suppliers that sell press fit components have done a good deal of work to qualify the component and will have all the specifications yo

Re: Press for press fit connectors

Electronics Forum | Mon Oct 25 19:29:12 EDT 1999 | g cronin

hi mario there is a company called motion automated that makes a nifty press, i have one in my shop that i have used for a while. well built and they have been able to make me custom tooling as well at reasonable prices. i'm going to try to dig u

press fit on Ni/Au board finish

Electronics Forum | Mon Apr 29 03:16:43 EDT 2002 | Bob Willis

I have only seem problems so I would suggest you don't do it.

press fit on Ni/Au board finish

Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan

Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati

Press fit

Electronics Forum | Tue Mar 07 20:33:26 EST 2023 | SMTA-72027903

Hello We have recently started to work with press fit but we are finding problems to reach the specifications in terms of hole deformation and whiskers. Do someone have experience in key process parameters and PCB design specifications (PCB harness,

  1 2 3 4 5 6 7 8 9 10 Next

press fit fixture searches for Companies, Equipment, Machines, Suppliers & Information