Electronics Forum | Mon Jun 29 19:36:08 EDT 2009 | proy
Are you sure it is the Z axis, and not the rotation, I had one machine which often did something similar, it would buzz loudly, especially if you touched or applied rotation pressure to the gear belt which rotates the head. It never caused any hard s
Electronics Forum | Wed Jul 01 13:41:25 EDT 2009 | jlawson
Are you sure it is the Z axis, and not the > rotation, I had one machine which often did > something similar, it would buzz loudly, > especially if you touched or applied rotation > pressure to the gear belt which rotates the > head. It never ca
Electronics Forum | Thu Jan 21 15:36:37 EST 2016 | brantco
I have the Error message E00900 i have checked the troubleshoot and it says to check SP1 XP6 and Y1 i have checked SP1 its ok, Relay XP6 seems ok Y1 i dont know where it is located here is the error "Air Pressure Fault" any help would be greatly
Electronics Forum | Thu Apr 14 05:23:10 EDT 2005 | dj_jago
What is the pitch of the device and what type of flux are you using? You may eridicate the fault by using a more active flux. I assume you are flowsoldering the device as opposed to paste in hole. Do you have an air knife? If so, you could tr
Electronics Forum | Thu Apr 14 14:29:37 EDT 2005 | shagnasty
MPM Help!? On start up when my machine is comping up to the start screen i'm getting a air pressure fault please help. Email @ hillardb@protekelec.com or call me direct @ (941) 915-5134 Thanks Brian
Electronics Forum | Thu Aug 17 19:29:54 EDT 2006 | foxhound
Im having problems with my ap 25. I get the air pressure fault alarm when it boots up so I bypassed the air pressure switch but I still get the alarm. The air routes through the machine as soon as I hit the on button, I thought it wasnt suppose to
Electronics Forum | Mon Jan 25 15:51:02 EST 2016 | aemery
SP1 is a bi-metal spring loaded switch or the "air fault" switch on the main air manifold that detects the presence of an appreciate amount of air being supplied to the machine. Air pressure overcomes the adjustable spring and closes the contacts.
Electronics Forum | Wed Jul 27 22:43:10 EDT 2005 | crishan
Hi all, Having a major problem with an IC being placed upside down. We pick up the fault at AOI. We have check several reels and the component is not placed upside down by the supplier. Where should I start looking; 1. Are we using an incorrect fee
Electronics Forum | Sat Jan 15 16:45:46 EST 2022 | goseese
I don't seem to be finding any loose connections. I am starting to suspect perhaps the rising table driver, BGE9010C, or the Motor it's self. I just don't know how to prove one or the other. How sensitive to pressure should the table be? While jo
Electronics Forum | Tue Apr 04 04:55:31 EDT 2000 | Jesper K
It's a typical answer from a board fabricator - 'None of our other customers have these problems'. But, and correct me if I'm wrong, none of the other customers uses the same PCB's as you do! Your preheat-parameters looks OK - they should not be giv