Electronics Forum | Thu Jan 04 13:12:22 EST 2007 | russ
do not touch copper boards, use cotton gloves. IPC 610 has some handling guidelines that you may want to look at. Russ
Electronics Forum | Wed Jan 03 23:00:18 EST 2007 | new guy
I'm a new guy in this field. I have a question about solder paste process. Is there any effect to the solderbility if we do a lot of contact to copper pad without using any insulation ( direct to the finger ). Where can i get information about smt pr
Electronics Forum | Mon Jun 24 15:51:13 EDT 2024 | erikfriesen
Using horizon 02i, I'm trying to program the print area of a board outside of just the board width. It seems that print front and print rear limit has no effect on the print area. Any suggestions on a solution?
Electronics Forum | Mon Mar 24 14:19:36 EDT 2008 | burb1999
I have a DEK ELA and here is what happens. I print a board after going through the step and it is a dead on print. Then, with another print it will be off in Auto mode (sometimes up and sometimes down, seems to just be up and down not left to right
Electronics Forum | Mon Feb 20 17:12:54 EST 2006 | mark
Hallo all, I have recently had possibility to work with DEK265. I have met with problem poor print definition (no sharp edges). I used stencil 150 thickness, metal squuegees. I moved than the same stencil, squeegee and parameters to DEK nifinty and
Electronics Forum | Thu Dec 06 02:45:09 EST 2007 | mun4o
hi, we use pump print stencil and have problem with cleaning.we clean the stencil handling, using zestron301, but in the holes stay adhesive.Take a test with ultrasonic cleaner but resalt is not good.
Electronics Forum | Mon Mar 24 15:54:36 EDT 2008 | Paul M.
What r u using for fiducials ? fids? pads? thru-holes? video model? What r u using to print the paste? squeege blades? proflow? paste puck? Why r u using Step Mode ?
Electronics Forum | Tue Mar 25 14:27:16 EDT 2008 | smtnet51
Make sure whatever you are using for a fid. is apart from any other pads or apertures. It'll grab a pad/aperture above or below (in auto mode) and screw up your print. We saw this alot when using pads for fids on DEKs.
Electronics Forum | Fri Mar 17 09:03:52 EDT 2017 | daleb
Hello New to forum, I have a mpm ultra print 1500 can not find a lube coupler for the Z axis slide bearings. Does anyone know what it is and where could I find one. A standard grease coupling does not fit. Thanks Dale
Electronics Forum | Wed Jun 23 22:18:51 EDT 2004 | PCA
Does any one have a copy of the error diagnostic code listing for this machine?
