Electronics Forum | Tue Jan 06 09:33:06 EST 2009 | blnorman
Years ago when we ran a solder paste evaluation we used the 2.4.44 method mentioned above. What we did was to print several coupons and let them sit for various times to see how the tack changed over time. Our goal was to see how long after print w
Electronics Forum | Wed Apr 08 10:23:38 EDT 2009 | cyber_wolf
I am assuming this machine has a tactile sensor that mounts to the printing table. If the air connection or any of the wire connectors get under the rear rail it will cause the Z to fall. Also any bare wires on the tactile sensor that touch the prin
Electronics Forum | Wed Jun 24 03:20:08 EDT 2009 | hayee
Hi, I want to make a small setup for manufacturing PCB's based on SMD's for (pototyping boards, etc). I don't know clearly what are the equipments required for this purpose. I have an idea that we have to use (Pick n place station, Screen printing
Electronics Forum | Wed Sep 23 10:48:39 EDT 2009 | scottp
I did see ESD issues years ago when we tried using a plastic stencil to print SMT glue. We measured a huge charge on boards indexed out of the printer. I tried ionizing fans but that didn't help. We now only use metal stencils for printing adhesiv
Electronics Forum | Fri Nov 13 04:45:30 EST 2009 | lococost
Hi dave, Sorry to hi-jack the tread a bit, but,we are experiencing some problems with components falling off somewhere in our factory, you made me think about printer settings being an issue. By print print, do you mean a double sweep of the squeeg
Electronics Forum | Thu Apr 01 18:13:19 EDT 2010 | dman97
Since my last post, I have successfully calibrated my printer. Now I have noticed that after a print, the machine decides to check for fiducials again. A post print fiducial check. Do you know how to disable this? It is slowing down my process co
Electronics Forum | Thu May 27 16:29:26 EDT 2010 | jlawson
Milara has released a inline stencil printer with jet printer in same machine - combi functionality. Not as fast in terms of jetting speed as mydata (uses Asymtek jet head) Can print only, jet only or both to say top up paste on certain areas after
Electronics Forum | Fri Jul 02 09:27:36 EDT 2010 | remullis
I am new to flex circuit manufacturing, placing SMT. We have a need to use this technology, but I have no experience in the process. The sample our design engineers have obtained are from a company called Allflex. How does this process work? printi
Electronics Forum | Fri Jul 30 19:27:40 EDT 2010 | dman97
Hi All, Does anyone know how to repair a UP2000 that has the front squeegee lower than the rear? Can this be fixed by playing with the drive belts? The front squeegee is sitting lower than the rear and thus gives an uneven print stroke. The front s
Electronics Forum | Tue Nov 02 08:36:51 EDT 2010 | rgduval
Michelle, Our experience with no-clean solder pastes has been that water washing a mis-print is a bad idea. We've found that DI water does not do a sufficient job removing the no-clean paste (the same goes for stencils). Instead, we have washed no