Electronics Forum | Tue Apr 17 02:34:58 EDT 2007 | Wayne
Now, they realized the problem of the current leadfree alloys. Is there any leadfree alloys finalized to use in future? Will it be a four elements alloys instead of current three elements alloys (eg SAC)?
Electronics Forum | Wed Apr 18 02:59:17 EDT 2007 | lococost
lol, you see, all our problems will soon be solved with SodiT potatium solder, dont worry!
Electronics Forum | Fri Apr 20 00:02:11 EDT 2007 | Haris
Hi all, Recommended grease for Yamaha YV 100Xg is NSK grease NSL but i have a problem to find its direct supplier. thanks.
Electronics Forum | Mon Apr 23 09:40:51 EDT 2007 | greg york
Strange that, I heard one guy had problems with Tin,Copper Nickel alloy were the Impellar dissolved in 9 weeks it was in a HASL machine. Best regards Greg
Electronics Forum | Sat Apr 21 08:26:57 EDT 2007 | Cmiller
Has anyone experienced a problem with conformal coating adhesion to IS-410 boards? We are having problems with one suppliers boards. IS-410 boards from other suppliers are fine and all FR-4 boards that I have looked at are fine. We are using Conap
Electronics Forum | Thu Apr 26 17:41:33 EDT 2007 | JD
We've had our Aqueous Technologies 600-LD for four years or so now with just about zero problems... good luck in your selection
Electronics Forum | Wed May 02 11:28:32 EDT 2007 | Scotceltic
Might seem too simple but make sure your fids are defined and locking on correctly. Also, run frequent center checks on your nozzles.
Electronics Forum | Mon Apr 30 14:17:35 EDT 2007 | slthomas
My specific gripe is with the following statement: "Since the U.S., and thanks to Bush and his like,..." The debate as to why he's in this pickle could go on for a very long time and it doesn't have anything to do with resolving his problem.
Electronics Forum | Wed May 02 07:47:21 EDT 2007 | Bob R.
Don't dink with the profile until you have evidence that the profile has something to do with the problem. Step 1 is a cross-section. Where are the joints breaking? Do the joints show signs of proper wetting & intermetallic formation?
Electronics Forum | Thu May 03 10:45:27 EDT 2007 | mmjm_1099
Make sure you check to see that they are not lead-free balling and using leaded profile. We had this and had continous problems. We had to send out our BGA to get reballed.