Electronics Forum | Fri Aug 20 10:07:09 EDT 2010 | dan_ems
Hello, I have the same problem ..., please take a print screen with the profile to see how is made it. Thank !
Electronics Forum | Wed Sep 01 07:44:36 EDT 2010 | sachu_70
Dear SMT-manufacturer, I would recommend to also have other device joints on board X-ray inspected to understand if void formations are seen across the board or confined only to one component. If seen across, your "Reflow Profile" could be the cause
Electronics Forum | Tue Sep 07 12:57:00 EDT 2010 | jrr3434
Thanks for the info mike. How well do these batch cleaners work with densely populated through hole boards that were solder with no clean flux? Is there a problem with water getting trapped under large capacitors? I'm using kester 959t for flux on b
Electronics Forum | Fri Sep 03 08:25:30 EDT 2010 | remullis
I removed the muffler yesterday and still had the latch releasing issue, the latch was tight, however the table had some play in it. I adjusted the play out of the table, setup table zero and it fixed the problem. Same symptom as if the latch were lo
Electronics Forum | Tue Sep 28 15:33:53 EDT 2010 | babe7362000
V-Tek TM-50 is a great machine. We have had it about 5 years and never had a problem with it. Easy to setup and easy for the operators. Hope that helps...
Electronics Forum | Sun Sep 12 12:45:56 EDT 2010 | tony1
Hi there, does anyone experience in NiPdAu solderability dip & look test? I experiencing solder non wet issue on side I/O & also center ground for QFN package. Appreciate someone can offer me a solution. Thanks
Electronics Forum | Tue Sep 14 02:12:22 EDT 2010 | genesan
Hi Sir, Thanks for reply and base on our system the same part are using for 2 model only and the problem occur on both assembly.By the way as feedback it happen on random pin of this BGA only.
Electronics Forum | Thu Sep 16 08:47:39 EDT 2010 | headlad
I extended the pads to help ensure the component locates correctly and to allow for easier re-work should problems occur. I reduced the thermal by 5% but you may want to speak to your fabricator and ask what they require to ensure that the resist is
Electronics Forum | Thu Sep 16 16:18:14 EDT 2010 | cbudzinski
we have been using DESCO Statshield Protective smock for about 7 months and some are starting to fail test. Is anyone else having any problems?
Electronics Forum | Mon Sep 20 13:55:37 EDT 2010 | jamyboy
Check to make sure that the front and back of the DEK265GSX covers are closed. I have seen issues where the back cover trips its interlock and people go other places to look for the problem.....hope this helps