Electronics Forum | Thu Jun 11 05:36:28 EDT 2015 | jlawson
Valor MSS NPI is far more powerful than all the lower cost solutions, I had customer assess all their lower cost solutions and found no real added value, if want more than just SMT programming. NPI needs Stencil Optimisation , DFM analysis, DFT engi
Electronics Forum | Wed Oct 03 23:42:32 EDT 2018 | gaintstar
SMT Reflow Oven Factory http://www.flason-smt.com/product/SMT-Reflow-Oven-Factory.html Introduction of SMT Reflow Oven Factory: 1. Windows XP platform, user friendly interface and easily swap between bilingual of English & Chinese. 2. Digital contr
Electronics Forum | Fri Jun 02 13:47:06 EDT 2023 | tommy_magyar
The Tucano is easy to use, user friendly menu, easy debugging if there is a problem. The thing is, this one is ages old and had some problems previously which required a near to £10k investment (controller board replacement and some calibration) but
Electronics Forum | Fri Jan 15 16:55:50 EST 1999 | Chrys
| | | Hello, | | | | | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | | | | | So far, the tests I can think of performin
Electronics Forum | Wed Jul 14 09:26:55 EDT 1999 | Dave F
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 09:56:54 EDT 1999 | Wolfgang Busko
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 19:09:54 EDT 1999 | JohnW
| | | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stic
Electronics Forum | Sat Feb 14 19:35:51 EST 1998 | C. Lao
Mr Lao We have some specialist knowledge on this subject and offer both equipment and services for these tests. My first recommendation is that take coupons manufactured by your PC Fabricator and then samples at each manufacturing stage: Bare coupon
Electronics Forum | Thu Jun 21 22:04:18 EDT 2001 | davef
This is my attempt at beating the "Fuzzburg 7" translator used on the SMTnet Forum that mashes everything it sees. Below the next paragraph are three paragraphs,each with a common numering sequence, where each paragraph represents the columns of a t
Electronics Forum | Thu Oct 15 11:04:53 EDT 1998 | Justin Medernach
| | It seems like most people want to X-Ray their BGAs. We're going to start doing a lot more of them and need to consider X-ray, too. | | Q: Do most people/companies X-ray everyBGA or do they just do SPC? | | Q: Can you get away with spending 25K?