Electronics Forum | Fri May 20 10:11:50 EDT 2005 | davef
Emerson Ventilation Products 10048 Industrial Boulevard Lenexa, KS 66215-1219 Phone: 913-752-6000 Fax: 913-752-6478 http://www.emersonvent.com
Electronics Forum | Wed May 25 05:21:43 EDT 2005 | ajaydoshi
Thanks, I will check & update. Checked Fan it is working fine. In this problem after power turn off if we start again their is no problem. Some time this problem occure at the start of day also ( no night shift production ) ajay
Electronics Forum | Mon May 23 22:30:36 EDT 2005 | Frank
Hi all, I am trying to solve a problem with a CP643E any help on it please,It stop during production on an error for (Outside Target Position). Cheers Frank
Electronics Forum | Wed May 25 09:56:27 EDT 2005 | jdumont
What is everyone using to secure their caps on products that go through ESS testing. We have been using Dow 3140 RTV but it takes too long to dry and I read that RTV isnt the best anyhow. Any suggestions...
Electronics Forum | Thu May 26 15:28:41 EDT 2005 | jh0n!
It looks like there's another one or two threads somewhat similar, but allow me to pose another. We've only about two years experience in SMD production, and we're just starting to really ramp-up. As we stand right now, I'm not recieving informatio
Electronics Forum | Thu May 26 15:52:25 EDT 2005 | pjc
I believe Aegis Industrial Software has a product to collect this data. Since all machines can be networked. Try contacting them at http://www.aiscorp.com Another is Technomatix, http://www.technomatix.com
Electronics Forum | Wed Jun 28 11:54:46 EDT 2006 | Scott Wischoffer
Fuji is always a good choice. Please let us show you the placement equipment we offer and how it would fit into your production environment.
Electronics Forum | Thu Jun 29 23:54:06 EDT 2006 | grantp
Hi, I think it's a good choice for a startup, and if your finding it's accurate enough. We only went Fuji because of our volume, and small errors were adding up, but if I was starting from nothing again it would be MYDATA because I could not afford
Electronics Forum | Thu Jun 02 07:48:35 EDT 2005 | chunks
We just pulled a lot of material out of China. Bad quality was #1 reason. Prices were nice but poor workmanship and cheap material was enough to shut our production down.
Electronics Forum | Mon Jun 13 16:09:33 EDT 2005 | mrmaint
We verify ours once a month using our calibration board. You can use any board once your profile is set for a specific product. All you are doing is checking the performance and repeatability of the oven.
