Electronics Forum | Wed Apr 21 17:34:48 EDT 2010 | stepheniii
Does it have to be one for both 1D and 2D? We scan barcodes we print with a 200 DPI printer which works out to 5 mil wide lines with no problem. 2D barcodes need a completely different kind of scanner. I know there are scanners that can do both but
Electronics Forum | Fri May 07 05:26:07 EDT 2010 | jlawson
Best have a chat to Rehm from their perspective. But galden does cost money. All depends on your production. Basically the more you run the machine, depending on design of machine, the more galden it uses... Open fixed mass galden type machines try
Electronics Forum | Thu May 13 21:24:16 EDT 2010 | davef
Jacki: That's exactly what we need to know, so that we can start slogging through this. [See we don't do well with broad, generalized questions. We don't have time to write dissertations. This is a task-oriented group.] Let's focus further: * Is
Electronics Forum | Fri May 21 15:36:54 EDT 2010 | pforister
Erli, Thanks for your feedback. The BGA hybrids were baked before production. I had a particular date code that we dis-continued using. This date code was consistently voiding near or above 25%. The other date codes still produced voiding on ave
Electronics Forum | Fri May 21 15:45:29 EDT 2010 | pforister
iv40, Thanks. The PCB that we are populating the BGA hybrid onto does not have holes in the vias. I think the manufacturer indicated that on their hybrid it has holes in pads. This hybrid is a PCB assembly with BGAs and other components populated
Electronics Forum | Tue May 25 12:43:00 EDT 2010 | jmedernach
I don't have experience with 1B73. I do have a ton of experience with CE-1155. There are a couple of gotchas with this material. First and foremost is that it HATES silicone residue. If the material is not sticking to parts and they aren't cerami
Electronics Forum | Fri May 28 13:44:15 EDT 2010 | emrtech
good point Sibbe, we also do a lot of engineering and changes from rev and having to order a new screen very time is a pain and money spent. no more having to wait for a screen to keep production running. has anyone been working with a solder jet pri
Electronics Forum | Fri Jun 18 12:40:09 EDT 2010 | stepheniii
Are you talking about mini stencils for individual components? If so we check here first http://www.circuitmedic.com/products/stencils.shtml I think circuit medic only has ones for parts they have done repair work for. Their selection is a bit unu
Electronics Forum | Wed Jun 30 12:45:59 EDT 2010 | rgduval
Dave hit the hottest issues. But, I would emphasize the cycle counting!! Your inventory will quickly lose control of scrap percentages. That is, you may set your system to, say, 5% scrap....but, your operator and/or machine may lose 10% on a parti
Electronics Forum | Wed Jun 30 12:48:40 EDT 2010 | rgduval
oh, yeah... there's a potential issue with AVL utilization per job; depending on how your system is set up now to handle this. If, say, one internal part number contains multiple vendor part numbers, and your MRP system defines which vendor to use