Electronics Forum | Thu Oct 26 11:41:53 EDT 2023 | proceng1
We currently use Loctite 348 chipbonder to secure large parts that will hang under the board when reflowing the second side. Rework has been complaining that they sometimes have to remove those parts to make repairs and it's difficult to remove them
Electronics Forum | Tue Nov 07 12:07:10 EST 2023 | tommy_magyar
We are mounting an microphone device (SMT package) onto a PCB - how? Surface mount line or hand soldering? Contamination can only come from the solder paste, solder wire, flux, or burning the component/PCB assembly during hand soldering. Unless the
Electronics Forum | Tue Sep 20 14:36:53 EDT 2022 | sarason
Have you considered using PCBSYynergy for the CAD conversion and bypass the gerber step. Then add in Programming by Ealead. https://ealead-e.ucoz.com/index/products/0-8 https://pcbsynergy.com This ends the breaking of QC by bypassing human process
Electronics Forum | Thu Nov 30 16:18:28 EST 2023 | proceng1
We have a customer that at one point had a dozen LED boards that were all very similar in size. They used Aluminum boards and I found that the difference in thermal mass between the assemblies was negligible considering the largest difference was ac
Electronics Forum | Thu Feb 01 16:00:37 EST 2024 | dharmendra
I am facing a ppm fluctuation issue. The customer provides a limit of 600 to 1500 PPM in the Reflow process and it should be under spec. But we are facing the issue during the running production and the ideal state ppm flucate sometimes goes below 6
Electronics Forum | Tue Mar 05 14:06:41 EST 2024 | mistrthou
We don't own one, I'm a bit interested to see what you end up with. We do have a triden pcb wash, and I know Aqueous Technologes makes a lineup of misprint and stencil cleaners. We had an engineer in from Zestron chemical company, and while they don
Electronics Forum | Fri Mar 08 16:10:44 EST 2024 | tommy_magyar
Unfortunately no sample numbers. We are building our own products, not a contract manufacturer. We are monitoring AOI, RMAs and rework - this only started in the last couple of months, but top management inclines not to give a target as it may "upset
Electronics Forum | Wed Mar 13 13:08:31 EDT 2024 | lambert
Section 8 in the J-STD-001 was the initial place to start with cleaning and the requirements, however with all the changes going on within the industry with increase product densities and such, a revision is being created to help understand the need
Electronics Forum | Thu Mar 14 15:55:34 EDT 2024 | davef
Process Requirement Standard - J-STD-001 - Requirements for soldered electrical and electronic assemblies depicting minimum end product acceptable characteristics as well as methods for evaluation (test methods), frequency of testing and applicable a
Electronics Forum | Tue Mar 19 14:57:48 EDT 2024 | spoiltforchoice
I hadn't suggested the IINEO's because as a step up from Neoden's its a huge leap in price and perhaps around twice the price of the AM100, that gap would narrow as you purchased even more feeders. If you have a big product mix or are a small batch