Electronics Forum | Wed Nov 02 04:19:59 EST 2005 | rlackey
There have been times when we could have done with having a Ken or 2; He may not always agree with everyone but he has demonstrated a very good process knowledge over all the time I've been using SMT net. Also I've never read one of his posts that w
Electronics Forum | Thu Nov 03 14:43:38 EST 2005 | slthomas
Tony, you said: "Steve, Dave has initiated this threat to find a solution for his Quad, but ultimately, it's to solve his production issues, my suggestions was to help Dave out if he wanted it. To make it clear, I did not advertize my company's name
Electronics Forum | Tue Nov 08 22:17:57 EST 2005 | grantp
Hi, I would be interested in the data, and I after our experience with batch convection I am quite skeptical. I would be very interested in temperature plots. What I would like to see before I ever considered a batch convection oven is how the oven
Electronics Forum | Wed Nov 16 09:22:24 EST 2005 | chunks
These are all good questions. Dip fluxing is fine. Make sure you let all the remaining flux drip off the board. Letting it drip into the pot will cause a lot of spattering of hot solder � be careful. Dipping the board slowly into the pot should
Electronics Forum | Thu Nov 17 23:33:08 EST 2005 | darby
If the machine is on it's way..... Question is 1. What if the machine is on its way / remote site...and need to estimate (say 90-95%) probability ? A1. 1 x 8 hour shift 65% x 1 of software estimate or stop watch estimate run on same machine in a dr
Electronics Forum | Tue Dec 06 15:27:36 EST 2005 | Mike
Steve, You are correct in that X-Ray image of a BGA will not show flux residue. So what? If you are using no clean flux then I would think it doesn't matter if there is some flux residue. Sure if you are reworking a BGA and the operator dumps t
Electronics Forum | Wed Dec 14 12:48:21 EST 2005 | grantp
Hi, A second hand TP9-2U MYDATA could be picked up very low cost, however it will only load a single component at a time, which could be ok for your jobs. However if your running 0402, I am not sure if that model will do it accurately. Your machin
Electronics Forum | Sat Dec 17 15:46:28 EST 2005 | Csabee
Samsung SM320 don't have sensor for recognizing component. Only using Fly&Fix camera. In first time the korean samsung service engineer advised me (3,7light settings for chips and the machine generated many dumps, sometimes 50 or more per day. But n
Electronics Forum | Wed Dec 21 08:31:13 EST 2005 | DannyJ
Hi AJ, First, I am not intimately familiar with your wave, but I will share some experiences I have had with other products. First, I would check to make sure that all of your heaters are working. Simply go to the electrical connections, remove p
Electronics Forum | Thu Dec 29 09:20:30 EST 2005 | Cmiller
We have tested SN100C and SAC305 in our selective solder machine (Ersa Versaflow). We wanted to test both alloys in the selective first because the investment in filling the pots is minimal. In our initial tests the SN100C alloy appears to be the bes