Electronics Forum | Mon May 01 10:25:53 EDT 2006 | Chunks
Slamming someone about spellcheck whilst starting a sentence with a small case "i"? You need to fill your Author name with either a "Master" "Doctor" or "Professor" wording to get away such demeanor! That is, unless you have a carnival mirror and s
Electronics Forum | Tue May 02 15:33:23 EDT 2006 | mdm4ua
I have five Mydata machines. The 21000 number is pie in the sky. Our new My12E (2 months old) won't get close to that. Having said that, I am very happy with 0201 production with the Hydra/line scan/Linear Agilis combination. Mike
Electronics Forum | Thu May 04 02:07:44 EDT 2006 | CW
Hi, There are a couple of Omniflow 7 and 7E that are being used in the production. Recently we found a lot of flux clogging up the exhaust ducts. Anybody who uses the same type of tool who has seen this kind of problem? How can we fix this? Does
Electronics Forum | Fri May 05 08:42:08 EDT 2006 | Chunks
This used to ba a hot topic years ago. But surface mount equipment does not need to be in a clean room. Your product may need to be , which would drive toward a "standard". Some people assume that "clean room" mean "high quality". Next time hav
Electronics Forum | Wed May 17 16:20:36 EDT 2006 | jh0n
I've been using an Excel plugin called Synkronizer with a LOT of success. I export a BOM from Orcad, 1 part/ref per line (2 columns), for each product I want to compare. Synkronizer does the rest - highlighting in different colors for deletions, va
Electronics Forum | Fri May 12 18:54:20 EDT 2006 | Ola
Sometimes when I go fishing i'll use lead on the end of the line, just above the hook, so that the bait is going to the bottom or at least very deep into the lake. At work however, lead is a non wanted product. Well, I don't mix work and pleaure...
Electronics Forum | Tue May 16 04:30:52 EDT 2006 | Rob
Take some of your boards along & run them. Try the same with the other alloys and see which suits your products best (make sure you make a note of the fluxes being used, and if the machines have similar preheats, nitrogen etc than yours).
Electronics Forum | Wed May 31 10:39:33 EDT 2006 | grantp
Hi, We actually tried to get major parts of our line from the same supplier, however each supplier is good at some parts of the line, and not others. We went with Soltec oven and wave, which work well, and have not had any issues, plus DEK printer
Electronics Forum | Fri Jun 16 08:45:35 EDT 2006 | Chunks
It's hard to say since cleanliness on my product may be acceptable, but may fail on yours. If you really are worried about flux residues, or need to pass some cleanliness spec, you may want to look into water soluable. Otherwise, most of the name b
Electronics Forum | Thu Jun 15 19:01:32 EDT 2006 | Solder Iron
I have to hold parts down in my wash baskets. I heard there is a rubber mat with cut outs similar to the screen mesh that the wash basket has. This mat goes over the boards and keeps them from moving through the wash cycle. Has anyone seen this produ