Electronics Forum | Mon Mar 06 13:02:49 EST 2006 | Chunks
Although rather expensive, you have to realize they had to go through extensive testing to prove their product safe. This probably cost them extensively. So once the formula has been deemed safe, they just pass this cost onto the consumer. Not to
Electronics Forum | Mon Jul 18 02:47:27 EDT 2005 | grantp
Hi, It sounds like your a little new at profiling, and can be difficult to do well. We purchased a KIC profiler that has software that will take your profile data and tell you the best oven temperature settings and conveyer speed to use. You need
Electronics Forum | Tue Jul 24 12:48:45 EDT 2001 | kerryn
Can you tell me a little bit about the Zestron product. How many stencils do you clean and much Zestron do you use per month? What is the cost? Do you mix it with water? If so, what temperature? How do you get rid of the waste? Thanks. Kerry
Electronics Forum | Fri Jan 11 16:10:03 EST 2008 | jlawson
Do you have your own data caputure software ? Check out VManage from Valor if you do not. They have machine monitoring solutions for most FUJI equipment QP351 I would say would be covered. Even the latesr machines are coverd from Fuji...
Electronics Forum | Fri Jul 09 19:27:10 EDT 2010 | rway
I am looking at using a bridge handler with our ICT machine. Does anyone have any experience with this equipment or have done something similar on your own? I need advice on what works best and companies and/or contacts that can provide the best af
Electronics Forum | Thu Jul 12 17:52:06 EDT 2007 | swag
Are you talking about problems with your product or your SMT/wave solder equipment?
Electronics Forum | Fri Jul 13 09:43:16 EDT 2007 | lococost
wow, never heard of such a thing! Are you sure it's allways different types of material? Are you using a washer that isnt cleaned regular? I would check your product step by step, from bare PCB to finished product to find out where exactly in your
Electronics Forum | Wed Mar 23 02:51:50 EST 2005 | Base
Hi Evtimov, Try to stay away from GEM or SECS/GEM. It's waaaayyyy to complicated and every vendor has there own interpretation of it when it comes to events and reports that are not commonplace in the semiconductor industry, which is where the GEM-s
Electronics Forum | Fri Jul 13 09:27:15 EDT 2007 | losersk8er
Sorry I have just started working in this industry so I am not as familiar with everything. The probelm is with the Product shorting because of small pieces of metal stretching accross two leads of an IC. This could be a result of faulty equipment?
Electronics Forum | Fri Jul 13 11:33:54 EDT 2007 | realchunks
Just starting and already responsible for product quality and machine adjustment? Wow, you poor bastard. Ok, I will assume this problem happens on the bottom side of the board with a thru-hole IC. The short occurs on the side that doesn't have the
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830