Electronics Forum | Thu Feb 17 22:23:15 EST 2000 | Dave F
Richard: As Roni said, most of the better profiler companies have the capabilties you seek Datapaq,187 BallardvilleSt,Wilmington, MA 01887 508.988.9000 Michael Dougherty Electronic Controls Design, 13626 SFreeman Rd, MulinoOR 97042 503.829.9108 K
Electronics Forum | Thu Dec 21 14:29:08 EST 2000 | CEFD
There must be a good reason for somebody to say that; I just can't think of one. We have a CRT and there is an issue with flux affecting the performance of the machine, but it is not terribly bad. Run your reflow profile the way it is supposed to run
Electronics Forum | Mon Dec 11 17:09:27 EST 2000 | Michael Parker
Get a profiler for your oven. To say "we are not sure" and "we think it might..." shows you are running with a WAG (Wild Ass Guess). Not a good place to be if you intend to produce anything reliable, with quality. Run your profile and verify that yo
Electronics Forum | Thu Oct 26 12:40:49 EDT 2000 | NLykus
Antonio, I would need to have more profile information i.e. preheat temp (hold time) as well as soaking zone (time). What is the peak temperature and how long is it held there. Also, one more thing to check, because I have seen it in the past, is
Electronics Forum | Tue Aug 15 02:21:33 EDT 2000 | Dreamsniper
Hi, I've updated my smtnet personal profile almost 2 months ago and it seemed that it is not affecting my smtnet records. I've moved to another company and changed my old company e-mail to my present address but I didn't receive any notification from
Electronics Forum | Mon Aug 14 10:35:00 EDT 2000 | C.K.
We've got this power brick device with a Copper casing that gets so hot in the oven, that the solder on the circuit board inside the power brick reflows. Of course, the heat is abosorbed by the case. Profile adjustments have been tried, but we don'
Electronics Forum | Tue Jul 11 11:59:34 EDT 2000 | George English
Looking for some welcome advise again folks. We are currently using a reflow profiling software package which requires passing a data logging unit through the oven attached via thermocouples to a populated 'dummy' PCB. The problem is we have a very
Electronics Forum | Fri Apr 28 13:23:22 EDT 2000 | Chris McDonald
We have had nsome new products come in that require Bottom side wave soldering (SMT). I have SOIC's 1206, 0805 that are Glued then Wave soldered. I have had trouble with bridging and no-clean residue with these pcbs. I have a Econopak 2 SMT two zone
Electronics Forum | Tue Feb 22 11:53:16 EST 2000 | JAX
Sal, To answer your first statement; Yes, you can cure paste and reflow solder using one profile. Question on your second statement; Are you talking about running passive side glue, flipping it over, running active side solder, and then putting the
Electronics Forum | Thu Feb 17 22:23:15 EST 2000 | Dave F
Richard: As Roni said, most of the better profiler companies have the capabilties you seek Datapaq,187 BallardvilleSt,Wilmington, MA 01887 508.988.9000 Michael Dougherty Electronic Controls Design, 13626 SFreeman Rd, MulinoOR 97042 503.829.9108 K