Electronics Forum | Mon Dec 21 10:20:47 EST 2009 | zanolli
We are looking to purchase a table top batch oven, with nitrogen, for prototype work on various PCB assy's - some with BGA's. The intent is to simulate a multi-zone production oven profile - and we kow that an exact simulation is not possible - just
Electronics Forum | Tue Mar 09 11:10:31 EST 2010 | baildl632
Graceyt, I know you are being shot a lot of info. Have you gotten any resolution to this problem? I've seen similar problems in our thermal chamber with Demodulation units. The IC, in the module, inside the radio inside the chamber at the top of ou
Electronics Forum | Wed Feb 17 14:45:40 EST 2010 | dcell_1t
Is your oven adjusted correctly for temperature > and blower and conveyor speed? As far as blower settings it only has a Hi-Mid-Low setting (is a heller 1809), and we have been working with all at Hi speed since line was started (1.5 year ago). Co
Electronics Forum | Wed Mar 03 01:48:57 EST 2010 | 89jeong
Hello Sir. Our customer asked me why the solder did not cover the surface of the potocopuler lead. There are 2 ea of photocopuler on pcb and the leads are totally 8ea. But only one is showing this problem. When i reviewed the reflow profile, there
Electronics Forum | Wed Mar 03 23:07:59 EST 2010 | davef
If your "engineer reviewed the reflow profile and said this was not related to reflow conditions," then what does he think it's related to? We think that a increased effort to improve the thermal recipe to solder this part is required, because: * S
Electronics Forum | Wed Mar 10 18:42:34 EST 2010 | 89jeong
Hello Sir. We also encountered the same pin-hole issue but there was around MLCC.I also looked for some information in technical report and internet, But i failed to get an answer. As you know this pin hole or blow hole is caused by the solder boilin
Electronics Forum | Thu Mar 25 09:14:09 EDT 2010 | krish_bala
Hello, I have been having some troubling issues when it has come to BGA Placement and I was hoping if there have been others who have been able to resolve similar issues. We are curently doing reworks on a variety of BGA, but seem to be having issu
Electronics Forum | Thu Apr 01 14:43:26 EDT 2010 | cbart
You say its in both smt and through hole, but, are you waving the SMT parts as well, I assume yes since you think its dross in the joints. Questions: 1- do you have higher mag scopes that you can zoom in a little more to see if these are voids or dr
Electronics Forum | Mon Apr 26 03:04:15 EDT 2010 | grahamcooper22
I always fix thermocouples to pcb pads across its width. Then rotate it 180 degrees to check readings. If I am happy that the oven is giving results within a few degrees C then I'll crack on and set up a soldering profile. I am not sure what the oven
Electronics Forum | Wed Apr 21 14:32:52 EDT 2010 | remullis
These ovens maintain good profiling as long as you stay on top of maintenance. I had 4 150's and 1 125. The biggest headache is keep the plenums cleaned (very messy). Also the blower motors have been replaced a few times on them as well. If I were yo