Electronics Forum | Thu Oct 14 18:02:31 EDT 1999 | JohnW
Bryan, 0402's tombstonning isn't that uncommon and usually the 1st reaction is alway's the pad size aint right. If you've followed the IPC guidline's normally you should be fine but I'd double check the component supplier's spec's as well. brian's p
Electronics Forum | Thu Jun 17 06:04:48 EDT 1999 | Ron G. Belliard, EET
RE: Cracked Capacitors: I have worked for 3 1/2 yrs with SMTA and have found a similar problem with capacitors. Throughout my studies of the problem, I have discovered three contributing factors that caused this cracking either individually or in co
Electronics Forum | Tue Feb 10 21:12:08 EST 2009 | smartasp
Dear ALL Thanks for the valuable input so far. The solder results is the first priority whereby the solder paste requirements sets the guidelines for the profile first. We use Kick profiler with the latest software. We verify the oven temp and dist
Electronics Forum | Fri Jul 26 09:34:10 EDT 2019 | spoiltforchoice
I've mostly been looking at the smallest oven in the range of the bigger ovens as it were. So that's the 1707 from Heller and similar sized units from elsewhere. However apparently Heller are apparently bring back the 1500 series in the form of a 150
Electronics Forum | Wed Jul 14 13:22:51 EDT 1999 | kt
| I am trying to solder a 388 ball BGA to an Andon Electronics Corp. BGA socket adapter and I am having problems in the reflow of this part. I put no clean paste flux in the solder cups of the adapter then put the BGA part onto the adapter and run it
Electronics Forum | Fri Jun 15 22:00:23 EDT 2007 | grantp
Hi, Thanks for the reply guys, and this is interesting information. I had assumed that if we had a paste spec, and this was the spec for the solder to reflow correctly, then if I achieved that spec, the solder should perform correctly. However this
Electronics Forum | Wed Jul 13 14:50:29 EDT 2005 | rameshn
Dear Sir, We are manufacturing Computer Motherboards & Networking products (which are having 2 to 3 BGA Chips onboard) in our plant. we are having 2 nos of HELLER 1800W model Reflow Ovens. this model reflow oven is having 9 heating zones at both top
Electronics Forum | Mon Jun 16 13:57:48 EDT 2003 | James
Could anyone give me a basic profile temperature settings for a conceptronics 7 zone oven and speed? I have the first couple of zones ramped up to get to the soak temperatures. Is this correct or should I start out with low temperatures and graduall
Electronics Forum | Sun Mar 20 12:58:23 EDT 2011 | sellenzz
We have a Nitrogen Silo. Your going to want to be careful if you decide to use nitrogen, not only are the levels unstable most of the time but it can also cause your components to tombstone like crazy, especially if you run a lot of LED's. We run 24/
Electronics Forum | Mon Sep 07 02:10:37 EDT 1998 | Tom Blum
Hi Dick We've built up an SMD line for low volume, high product mix over the last two years. Some thoughts: - the reflow system shall have very big thermal power and reserve that results in the same profil with different thermal masses ie products. T