Electronics Forum | Sat Aug 20 15:22:26 EDT 2005 | Jaya
Hi There, Good Day 2 Every1.:) I'm in mid of issue of SMT Components (Resistor & Capacitor) Turn Yellowish issue after reflow oven. Is there anyone have handle this issue previoslly and what is the reason behind the components behaviour in such. Can
Electronics Forum | Sun Nov 24 09:54:24 EST 2002 | davef
On a HASL board that has poor wetting on the pad, consider looking further downstream in the process than your assembly shop. For instance, take a look at the bare boards. Look for solder mask bleed onto the pads. This will show-up on the outside
Electronics Forum | Wed Dec 13 19:40:38 EST 2000 | Jerry Wetzel, SME, EM/SME
Your profile must be precise, your stencil aperture sizes and shapes are very important, and the size of the pads on the boards should be very close to what the part manufacturer recommends. We had some trouble with hi-temp paste, and discovered tha
Electronics Forum | Thu Aug 09 12:36:26 EDT 2001 | Michael Parker
Adam- Mikie here. I too am placing 2 PBGA sockets on an assembly but they aren't mirror imaged. Thanks to the SMT Gods for that one. You say you added more paste to solve for open solder. Do you have x-ray? Were the alignments perfect? Also the part
Electronics Forum | Mon Mar 21 02:41:29 EDT 2011 | kemasta
Hi It's me again. Our products need to pass a chamber test 45c/36hrs after the PCBA completed batch of functional tests and assemble in to case. We found 1 unit was functioning for 24hours in the chamber, but hang after that. We tried to re-boot the
Electronics Forum | Wed Feb 03 11:31:20 EST 2016 | steprog
Hi, New to this forum. I am an engineer assigned to resolve a quality issue on our production line. It seems that we have been getting small droplets of flux on our boards after the reflow process. Occasionally, they land on a board to board conne
Electronics Forum | Sun Aug 29 19:17:34 EDT 2004 | aqueous
Chen, It is always best to place one�s effort on determining the cause and content of the residue rather than trying to work around it. The first thing you must determine is the nature of the residue. Is it flux? In many instances, the residue is
Electronics Forum | Thu Mar 02 16:06:32 EST 2000 | eLDON sANDERS
Gentlemen, I too have been atacked by that "soldering to gold" and will add my 2 cents. I also had parts that would pop off the board when the fillet looked perfect. After lots of pain, experimentation, and sleepless nights, I solved it through a
Electronics Forum | Thu Mar 02 16:06:32 EST 2000 | eLDON sANDERS
Gentlemen, I too have been atacked by that "soldering to gold" and will add my 2 cents. I also had parts that would pop off the board when the fillet looked perfect. After lots of pain, experimentation, and sleepless nights, I solved it through a
Electronics Forum | Wed Dec 20 22:24:03 EST 2000 | Greenman
Dave: In terms of heat transfer, air is 78% nitrogen, and the remainder is mostly (20.9%) oxygen (roughly the same molecular weight as nitrogen), with a bit of argon (0.9%), CO2, hydrogen, monosodium glutamate etc. So you would expect virtually no d
